Yamaha RX 397 MCXSP10 Manual - Page 19

OPERATION PLAYING AND RECORDING PLAYING AND RECORDING CAUTION Extreme caution should be exercised when you play back CDs encoded in DTS. If you play back a CD encoded in DTS on a DTS-incompatible CD player, you will only hear some unwanted noise that may damage your speakers. Check whether your CD player supports CDs encoded in DTS. Also, check the sound output level of your CD player before you play back a CD encoded in DTS. Playing a source 2 Press SPEAKERS A and/or SPEAKERS B on the front panel or on the remote control to select speakers A and/or speakers B. STANDBY /ON INPUT FM/AM l TUNING h EDIT MEMORY TUNING MODE MAN'L/AUTO FM AUTO/MAN'L A/B/C/D/E 1 2 3 4 5 6 7 8 PHONES SPEAKERS A B BASS 0 1 1 2 2 3 3 4 -5 4 5+ TREBLE 0 1 1 2 2 3 3 4 -5 4 5+ BALANCE 0 1 1 2 2 3 3 4 L5 4 5R LOUDNESS FLAT 1 2 -30dB 10 3 9 4 8 5 7 6 PURE DIRECT TAPE MONITOR VOLUME 16 20 12 26 8 40 4 60 ∞ -dB 2 0 SPEAKERS A B Front panel SPEAKERS A or B Remote control 51 2 1 SLEEP POWER CD/DVD PHONO TUNER STANDBY MD TAPE AUX SPEAKERS A B u PRESET d A/B/C/D/E + VOLUME - MUTE 2 4 4 Notes • Both SPEAKERS A and B can be selected. • Make sure that the IMPEDANCE SELECTOR switch is correctly set (see page 13). 3 Play the source. 4 Rotate VOLUME on the front panel (or press VOLUME +/- on the remote control) to adjust the sound output level. 1 Rotate the INPUT selector on the front panel (or press one of the input selector buttons on the remote control) to select the desired input source. INPUT Front panel or SLEEP POWER CD/DVD PHONO TUNER STANDBY MD TAPE AUX SPEAKERS A B Remote control Note You cannot select any input source while the TAPE MON indicator lights up in the front panel display. 16 20 12 VOLUME 26 8 40 4 60 ∞ -dB 2 0 Front panel + or VOLUME - Remote control 5 Press STANDBY/ON on the front panel again (or press STANDBY on the remote control) to finish using this unit and set it to the standby mode. STANDBY /ON or STANDBY Front panel Remote control 15