Yamaha RX 397 MCXSP10 Manual - Page 7

Front panel 1 CONTROLS AND FUNCTIONS CONTROLS AND FUNCTIONS 2 3 45 6 7 8 9 0 A INTRODUCTION STANDBY /ON INPUT FM/AM l TUNING h EDIT MEMORY TUNING MODE MAN'L/AUTO FM AUTO/MAN'L A/B/C/D/E 1 2 3 4 5 6 7 8 PHONES SPEAKERS A B BASS 0 1 1 2 2 3 3 4 -5 4 5+ TREBLE 0 1 1 2 2 3 3 4 -5 4 5+ BALANCE 0 1 1 2 2 DISPLAY LOUDNESS FLAT 1 2 -30dB 10 3 3 3 9 4 L5 4 5R 4 8 5 7 6 PURE DIRECT TAPE MONITOR VOLUME 16 20 12 26 8 40 4 60 ∞ -dB 2 0 B CD E (U.S.A. and Canada models) F G H IJ 1 STANDBY/ON Turns on this unit or sets it to the standby mode. See page 14 for details. Note In the standby mode, this unit consumes a small amount of power to receive infrared signals from the remote control. 2 Remote control sensor Receives infrared signals from the remote control. 3 Front panel display Shows information about the operational status of this unit. 4 EDIT Exchanges the assignment of two preset stations with each other when TUNER is selected as the input source (see page 24). 5 FM/AM Switches the reception band between AM and FM when TUNER is selected as the input source (see page 20). 6 TUNING l / h Selects the tuning frequency when TUNER is selected as the input source (see page 20). 7 TUNING MODE Switches the tuning mode between automatic (the AUTO indicator turns on as a result) and manual (the AUTO indicator turns off as a result) when TUNER is selected as the input source. 8 MEMORY Stores a station in the system memory (see page 23). Sets this unit to the automatic preset tuning mode (see page 21). 9 PURE DIRECT and indicator Allows you to listen to a source in the purest possible sound. The indicator above it lights up when this function is turned on (see page 16). 0 TAPE MONITOR Allows you to listen to the sound played back on the tape deck connected to the TAPE terminals on the rear panel of this unit. When the 3-head tape deck is used for recording, you can also monitor the sound being recorded. The TAPE MON indicator lights up in the front panel display when you press TAPE MONITOR (see page 17). Notes • When TAPE MON indicator lights up, you cannot select any input source. • To listen to the source selected with the INPUT selector, press TAPE MONITOR again so that the TAPE MON indicator turns off. • When TAPE (tape deck) is selected with the INPUT selector, this function will not turn on even if TAPE MONITOR is pressed. 3