Yamaha RX-777 Owner's Manual - Page 6

CONTROLS AND THEIR FUNCTIONS FRONT PANEL 1 2 NATURAL SOUND STEREO RECEIVER RX-777 STANDBY/ON 34 5 6 7 8 9 DOWN TUNING UP PURE DIRECT CD DIRECT AMP A/B/C/D/E 1 PHONES SPEAKERS A B MEMORY MAN'L/AUTO FM EDIT FM/AM 2 3 4 5 6 7 8 BASS 0 1 1 2 2 3 3 4 -5 4 5- - - TREBLE 0 1 1 2 2 3 3 4 -5 4 5- BALANCE 0 1 1 2 2 3 3 4 L5 4 5R TUNING MODE AUTO/MAN'L MONO LOUDNESS FLAT 1 2 -30% 10 3 9 4 8 5 7 6 REC OUT/ZONE 2 INPUT VOLUME 20 VCR · D-TV · DVD · TAPE/MD · TUNER · CD · PHONO TUNER TAPE/MD CD 28 DVD PHONO D-TV 40 VCR 60 ∞ 16 12 8 4 2 0 -dB 0q w e r t 1 STANDBY/ON switch Press this switch to turn on the power to this unit. Press it again to turn this unit into the standby mode. Standby mode In this state, this unit consumes a very small quantity of power to receive infrared-signals from the remote control transmitter. 2 Display panel Shows various information. (For details, refer to page 4.) 3 Remote control sensor 4 MEMORY (MAN'L/AUTO FM) button 5 TUNING DOWN/UP button Used for tuning. Press the "UP" side to tune in to higher frequencies, and press the "DOWN" side to tune in to lower frequencies. 6 EDIT button This button is used to exchange the places of two preset stations with each other. 7 FM/AM button 8 PURE DIRECT switch Press this switch so that the indicator lights up to listen to an audio source in the purest sound. (Refer to page 11 for details.) 9 CD DIRECT AMP switch Press this switch so that the indicator lights up to listen to a CD source in the purest sound. (Refer to page 11 for details.) 0 A/B/C/D/E button Press this button to select a desired group (A-E) of preset stations. yu i o p q PHONES jack w SPEAKERS A B switches Set the switch A or B (or both A and B) for the speaker system (connected to this unit) you will use. e PRESET STATIONS buttons Select a preset station number (1 to 8). r Tone controls BASS Used to increase or decrease the low frequency response. The 0 position produces flat response. TREBLE Used to increase or decrease the high frequency response. The 0 position produces flat response. t BALANCE control Adjusts the balance of the output volume to the left and right speakers. y Continuously variable LOUDNESS control Used to compensate for the human ears' loss of sensitivity to high and low-frequency ranges at low volume. u TUNING MODE (AUTO/MAN'L MONO) button i REC OUT/ZONE 2 selector Used to select an input source and supply that source directly to the REC output terminals on the rear panel, independently of the setting of the INPUT selector. This function allows you to record the selected source while listening to another source. o INPUT selector Selects the input source that you want to listen to (and watch). p VOLUME control Used to raise or lower the volume level. E-2