Yamaha RX-777 Owner's Manual - Page 8

CONTROLS AND THEIR FUNCTIONS s Battery installation 1 3 2 s Remote control transmitter operation range NATURAL SOUND STEREO RECEIVER RX-777 STANDBY/ON DOWN TUNING UP PURE DIRECT CD DIRECT AMP A/B/C/D/E 1 PHONES SPEAKERS A B MEMORY MAN'L/AUTO FM EDIT FM/AM 2 3 4 5 6 7 8 BASS 0 1 1 2 2 3 3 4 -5 4 5- - - TREBLE 0 1 1 2 2 3 3 4 -5 4 5- BALANCE 0 1 1 2 2 3 3 4 L5 4 5R TUNING MODE AUTO/MAN'L MONO LOUDNESS FLAT 1 2 -30% 10 3 9 4 8 5 7 6 REC OUT/ZONE 2 INPUT VCR · D-TV · DVD · TAPE/MD · TUNER · CD · PHONO VOLUME 20 TUNER TAPE/MD CD 28 DVD PHONO D-TV 40 VCR 60 ∞ 16 12 8 4 2 0 -dB If you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones. Notes • Use only AA, R6, UM-3 batteries for replacement. • Be sure the polarities are correct. (See the illustration inside the battery compartment.) • Remove the batteries if the remote control transmitter will not be used for an extended period of time. • If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries. DISPLAY PANEL Remote control sensor Within approximately 6 m (19.7 feet) 30° 30° Notes • There should be no large obstacles between the remote control transmitter and the main unit. • If the remote control sensor is directly illuminated by strong lighting (especially an inverter type of fluorescent lamp etc.), it might cause the remote control transmitter not to work correctly. In this case, reposition the main unit to avoid direct lighting. 1 2 3 45 MEMO 9 AUTO TUNED KHZ MHZ STEREO PURE CD DIRECT DIRECT SPEAKERS SLEEP A B 87 6 1 Multi-information display Displays various information, for example station frequency, preset station number and name of selected input source. 2 AUTO indicator Lights up when this unit is in the automatic tuning mode. 3 TUNED indicator Lights up when turned in to a station. 4 STEREO indicator Lights up when an FM stereo broadcast with sufficient signal strength is received. 5 CD DIRECT Lights up when CD DIRECT is on. 6 SPEAKERS A B indicator Lights up according to which set of main speakers is selected. Both indicators light up when both sets of speakers are selected. 7 SLEEP indicator Lights up while the built-in SLEEP timer is functioning. 8 PURE DIRECT Lights up when PURE DIRECT is on. 9 MEMO indicator When the MEMORY button is pressed, this indicator flashes for about 5 seconds. While this indicator is flashing, the displayed station can be programmed to the memory by using the A/B/C/D/E button and the PRESET STATIONS buttons. E-4