Yamaha RX-V571 Setup Guide - Page 3
Connecting speakers - canada
View all Yamaha RX-V571 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
3 Connecting speakers • (U.S.A. and Canada models only) The unit is configured to 8Ω speakers as the factory setting. 6Ω speakers can be also connected. • (Except for U.S.A. and Canada models) Use the speakers with an impedance of at least 6Ω. • Use a subwoofer with a built-in amplifier. • Disconnect the power plug before connecting the speakers. • Be careful that the core of the speaker cable does not touch anything or come into contact with the metal areas of the unit. If this happens, it may damage the unit or the speakers. If the speaker cables short circuit, "CHECK SP WIRES!" will appear on the front panel display when the unit is switched on. Connecting speaker cables Speaker cables have two wires. One is for connecting the negative (-) terminal of the unit and the speaker, and the other is for the positive (+) terminal. If the wires are colorcoded to prevent confusion, you should connect the black side to the negative terminal and the other wire to the positive terminal. 1 Remove approximately 10 mm (0.4 in.) of insulation + (Red) from the end of the speaker FRONT cable and twist the bare wire firmly. 2 Loosen the speaker terminal. - (Black) 3 Insert the bare wire into the gap on the side of the terminal. When it is difficult to insert the wire into the gap on the side, insert it into the gap downside of terminal. 4 Tighten the terminal. Connecting banana plugs (Except U.K., Europe, Asia and Korea models) Tighten the knob, and then insert the banana plug into the FRONT end of the terminal. Banana plug 1 Connect the front speakers ( / ) to the FRONT ( / ) terminals. The unit (rear) R FRONT L CENTER R SURROUND L SURROUND BACK/ R BI-AMP L SINGLE SPEAKERS SUBWOOFER 2 Connect the center speaker ( CENTER terminal. ) to the The unit (rear) R FRONT L CENTER R SURROUND L SURROUND BACK/ R BI-AMP L SINGLE SPEAKERS SUBWOOFER 3