Yamaha RX-V677 RX-V677 Firmware Update Installation Manual - Page 2

Enter the ADVANCED SETUP mode - manual

Get Yamaha RX-V677 PDF manuals and user guides View all Yamaha RX-V677 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 2 highlights

Firmware Update Through the Internet Requirement: Internet connection Your receiver is connected to the Internet if you can receive Internet radio stations. (See owner's manual for details) 1 Power off the receiver (Standby mode) 2 Enter the ADVANCED SETUP mode While pressing the STRAIGHT key, press the MAIN ZONE key and keep STRAIGHT key pressed until " ADVANCED SETUP " appears on the front panel display. * " ADVANCED SETUP " is displayed only for a few seconds. 3 Select "FIRM UPDATE" from the menu a. Press the PROGRAM key until " UPDATE.....USB " is displayed. b. Then, press STRAIGHT key until " UPDATE.NETWORK " is displayed. 4 Start firmware update a. Press INFO (WPS) key to start the update. (Update process may take up to 15 minutes) * If " UPDATE SUCCESS " appears, this means your receiver is already up-to-date. In this case, power off to exit from Advanced Setup. Your AV receiver is ready for normal use. Firmware update in progress Caution DO NOT interrupt power during the update. In case the power is accidentally cut off resulting in a condition where you can't recover normal operation, refer to the troubleshooting method (Troubleshooting CASE 2) on the last page. b. When completed, " UPDATE SUCCESS " appears on the display. c. Turn off the power of the receiver by pressing the MAIN ZONE key. MAIN ZONE key PROGRAM key INFO (WPS) key STRAIGHT key

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
MAIN ZONE
key
Firmware Update Through the Internet
Requirement:
Internet connection
Your receiver is connected to the Internet if you can receive Internet radio stations.
(See owner’s manual for details)
1
Power off the receiver (Standby mode)
2
Enter the ADVANCED SETUP mode
3
Select “FIRM UPDATE” from the menu
4
Start firmware update
While pressing the
STRAIGHT
key, press the
MAIN ZONE
key and keep
STRAIGHT
key pressed until
“ ADVANCED SETUP ” appears on the front panel display.
*
“ ADVANCED SETUP ” is displayed only for a few seconds.
a. Press the
PROGRAM
key until “ UPDATE
.....
USB ” is displayed.
b. Then, press
STRAIGHT
key until “ UPDATE.NETWORK ” is displayed.
a. Press
INFO (WPS)
key to start the update.
(Update process may take up to 15 minutes)
*
If “ UPDATE SUCCESS ” appears, this means your receiver is already up-to-date. In this case, power off to exit
from Advanced Setup. Your AV receiver is ready for normal use.
Firmware update in progress
Caution
DO NOT interrupt power during the update.
In case the power is accidentally cut off resulting in a condition where you can’t recover normal operation, refer to
the troubleshooting method (
Troubleshooting CASE 2
) on the last page.
b.
When completed, “ UPDATE SUCCESS ” appears on the display.
c.
Turn off the power of the receiver by pressing the
MAIN ZONE
key.
STRAIGHT key
INFO (WPS) key
PROGRAM key