Yamaha RX-V757 Owner's Manual - Page 71

ADVANCED OPERATION p p p p ■ Speaker distance C)SP DISTANCE Use this feature to manually input the distance of each speaker and adjust the delay applied to respective channel. Ideally, each speaker should be the same distance from the main listening position. However, this is not possible in most home situations. Thus, a certain amount of delay must be applied to the sound from each speaker so that all sound will arrive at the listening position at the same time. C)SP DISTANCE . UNIT;;;;;;meters FRONT L;;;;3.00m FRONT R;;;;3.00m CENTER;;;;;3.00m [ ]/[ ]:Up/Down []:Adjust Unit UNIT Choices: meters (m), feet (ft) Initial setting: U.S.A. and Canada models: feet (ft) Other models: meters (m) • Select meters to input speaker distances in meters. • Select feet to input speaker distances in feet. Speaker distances Choices: 0.3 to 24.00 m (1 to 80 ft) • FRONT L adjusts the distance of the front left speaker. Initial setting: 3.0 m (10.0 ft) • FRONT R adjusts the distance of the front right speaker. Initial setting: 3.0 m (10.0 ft) • CENTER adjusts the distance of the center speaker. Initial setting: 3.0 m (10.0 ft) • SUR. L adjusts the distance of the surround left speaker. Initial setting: 3.0 m (10.0 ft) • SUR. R adjusts the distance of the surround right speaker. Initial setting: 3.0 m (10.0 ft) • SB L* adjusts the distance of the surround back left speaker. Initial setting: 2.10 m (7.0 ft) • SB R* adjusts the distance of the surround back right speaker. Initial setting: 2.10 m (7.0 ft) • SWFR adjusts the distance of the subwoofer. Initial setting: 3.0 m (10.0 ft) • PRES L adjusts the distance of the presence left speaker. Initial setting: 3.0 m (10.0 ft) • PRES R adjusts the distance of the presence right speaker. Initial setting: 3.0 m (10.0 ft) * Instead of SB L and SB R, SUR. B will be displayed if you selected only one surround back speaker in SUR. B L/R SP (page 65). SET MENU ■ Center graphic equalizer D)EQUALIZER Use this feature to select the parametric (AUTO PEQ) or graphic equalizer (CNTR GEQ). Equalizer EQ TYPE SELECT Select to change the type of equalizer used by this unit. Choices: AUTO PEQ, CNTR GEQ, EQ OFF • Select AUTO PEQ to use the equalizer adjusted in auto setup. • Select CNTR GEQ to adjust the built-in 5-band graphic equalizer so that the tonal quality of the center speaker matches that of the front left and right speakers. • Select EQ OFF to cancel equalizing. Center graphic equalizer CENTER GEQ When CNTR GEQ is selected, use this feature to output a test tone and adjust the tonal quality so that it matches that of the front left speaker. You can adjust 5 frequency bands: 100Hz, 300Hz, 1kHz, 3kHz, 10kHz Choices: -6 to +6 dB Initial setting: 0 dB D)EQUALIZER . TEST )OFF ON - + 100Hz 0dB 300Hz 0dB 1kHz 0dB 3kHz 0dB 10kHz 0dB [ ]/[ ]:Up/Down []:Adjust • Select ON to output test tones from the front left and center speakers, and adjust the tonal quality of the center speaker. • Select OFF to stop the test tone and output the currently selected source component. • Press u / d to select a frequency band. • Press j / i to adjust the selected frequency band. 67