Yamaha RX-V757 Owner's Manual - Page 80
Setting remote control codes, L:CDR, L:MD, L:TAP tape, L:TUN, L:AMP - receiver code
View all Yamaha RX-V757 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
REMOTE CONTROL FEATURES Setting remote control codes You can control other components by setting the appropriate manufacturer codes. Codes can be set up for each input area. The following table shows the factory preset component (Library: component category) and the manufacturer code for each area. Remote Control Code Default Settings Input area A B PHONO V-AUX TUNER MD/CD-R CD DTV/CBL VCR 1 DVR/VCR2 DVD Component category (Library) LD CD-R TV VCR TUNER MD CD TV VCR DVR DVD Manufacturer Yamaha (U.K. and Europe models) Yamaha-1 (Other models) Yamaha - - Yamaha-3 (U.K. and Europe models) Yamaha-4 (Other models) Yamaha-1 Yamaha-1 - - Yamaha Yamaha-1 Note You may not be able to operate your YAMAHA component even if a YAMAHA remote control code is initially set as listed above. In this case, try to set other YAMAHA remote control code(s). 1 Press an input selector button to select the source component you want to set up. A B PHONO MULTI CH IN V-AUX TUNER MD/CD-R CD DTV/CBL VCR 1 DVR/VCR2 DVD 2 Press and hold LEARN for about 3 seconds using a ballpoint pen or similar object. "SETUP" and the selected component name appear alternately in the display window. LEARN Be sure to press and hold LEARN for at least 3 seconds, otherwise the learning process will start. y Complete each of the following steps in 30 seconds. Otherwise, the learning mode will be automatically canceled. In this case, press LEARN again. If you want to change a library (component category), press j / i. You can set a different type of component. Library choices: L:DVD, L:DVR, L:LD, L:CD, L:CDR, L:MD, L:TAP (tape), L:TUN, L:AMP*, L:TV, L:CAB (cable), L:DBS, L:SAT, L:VCR • The amplifier Library (L:AMP) code is preset to "ID1" to operate this unit. However, you can switch between the following two codes if necessary. The initial setting for "Amplifier library" is "ID1". AMP library code (remote control setting) Function ID1 To operate this unit using the (initial setting) default code. ID1Z To operate this unit using the default code. To operate Zone 2 or Zone 3 features (see page 83). (U.S.A., Canada, Europe and Australia models only) ID2 To operate this unit using an alternative code. ID2Z To operate this unit using an alternative code. To operate Zone 2 or Zone 3 features (see page 83). (U.S.A., Canada, Europe and Australia models only) Remote control ID (this unit's setting: see page 74) ID1 (initial setting) ID2 When using multiple YAMAHA receivers/amplifiers, you may be able to operate the other components simultaneously with the default code setting. In this case, set one of the alternative codes to operate this unit separately 76