Yamaha RX-V795 Owner's Manual - Page 18
Connections, Audio/video source equipment, Basic connections - component
View all Yamaha RX-V795 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
PREPARATION Connections Caution: Plug in this unit and other components after all connections are completed. All connections must be correct, that is to say L (left) to L, R (right) to R, "+" to "+" and "-" to "-". Also refer to the owner's manual for each of your components. Audio/video source equipment q Use RCA type pin plug cables for audio/video units with the exception described later. q The output (or input) terminals of YAMAHA audio/video units numbered as 1, 3, 4, etc. on the rear panel must be connected to the same-numbered terminals of this unit. Ⅵ Basic connections Turntable TV monitor LD player, DVD player, etc. OUTPUT GND VIDEO IN AUDIO OUT VIDEO OUT (*1) 75Ω UNBAL. FM ANT GND AM ANT GND EXTERNAL DECODER INPUT MAIN CENTER SURROUND CD OPTICAL DVD/LD DVD/LD TV/DBS COAXIAL OPTICAL DIGITAL SIGNAL S VIDEO VIDEO ON SCREEN SELECTOR IN OUT REMOTE CONTROL SUB WOOFER MONITOR OUT IN OUT VCR S VIDEO SIGNAL MONITOR OUT DVD/LD TV/DBS IN OUT VCR VIDEO SIGNAL PHONO CD 1 IN (PLAY) OUT (REC) 3 TAPE/MD 4 DVD/LD AUDIO SIGNAL TV/DBS IN OUT VCR (U.S.A. model) OUTPUT LINE OUT LINE IN VIDEO OUT AUDIO OUT AUDIO OUT AUDIO IN VIDEO OUT VIDEO IN CD player MD recorder, Tape deck, etc. (*1): GND terminal (For turntable use) Connecting the ground wire of the turntable to the GND terminal will normally minimize hum, but in some cases better results may be obtained with the ground wire disconnected. 14 TV/Satellite tuner Video cassette recorder : Indicates the direction of signals.