Yamaha RX-V795a Owner's Manual - Page 71

REMOTE CONTROLLER English Entering manufacturer codes If you have a component which is not a Yamaha model, you can enter the code for the manufacturer of the component in the corresponding position of the selector dial. By doing so, you can control the component with the remote controller. Refer to the code list at the end of this manual for the code numbers you need. Notes ● Some Yamaha CD players and tape decks cannot be controlled with the default codes. To control such a model, enter the code for the model in the corresponding position. ● If there is no code applicable for your component in the code list, you must use the remote controller provided for the component. Entering a code 1 Set the selector dial to the position for controlling the component. (For example, set to "VCR" for a VCR.) POWER STANDBY VCR Entering a code for a second (or third) VCR You can use the CBL/DBS or DVD MENU position, or both of them to control a second (and/or third) VCR if you do not use a cable TV, DBS tuner, DVD player etc. * If you will use the DVD MENU position for a second (or third) VCR, you must enter the code for an LD player in the DVD/LD position. /DTS SURROUND CD MOVIE THEATER 1 MOVIE THEATER 2 TAPE/MD 2 Press both of the VOLUME and keys at the same time and hold them until the indicator flashes twice. TV CODE SET MUTE VOLUME POWER STANDBY VCR Flashes twice. 3 Use the numeric keys to enter the four-digit manufacturer code for the component to be used. Make sure that the indicator flashes twice. /DTS SURROUND CD 1 MONO MOVIE DVD/LD 4 ROCK PHONO 7 HALL EXT. DEC. 0 MOVIE THEATER 1 TUNER 2 TV SPORTS TV/DBS 5 JAZZ CLUB V-AUX 8 +10 ENTER MOVIE THEATER 2 TAPE/MD 3 DISCO VCR 6 CHURCH 9 +TEST 100 CLEAR A/B/C/D/E POWER STANDBY VCR Flashes twice. * If the indicator does not flash, repeat step 3 and enter the code again. 4 Try operating the component with the remote controller to check the code entering is successful. Note If the component cannot be controlled, enter another code for the same manufacturer. 1 Set the selector dial to the CBL/DBS or DVD MENU position. POWER STANDBY DVDMENU /DTS SURROUND CD MOVIE THEATER 1 MOVIE THEATER 2 TAPE/MD 2 Press both of the VOLUME and keys at the same time and hold them until the indicator flashes twice. TV POWER STANDBY CODE SET MUTE VOLUME DVDMENU Flashes twice. 3 Press the MUTE key. TV CODE SET MUTE VOLUME 4 Use the numeric keys to enter the four-digit manufacturer code for the second (or third) VCR. Make sure that the indicator flashes twice. /DTS SURROUND CD 1 MONO MOVIE DVD/LD 4 ROCK PHONO 7 HALL EXT. DEC. 0 MOVIE THEATER 1 TUNER 2 TV SPORTS TV/DBS 5 JAZZ CLUB V-AUX 8 +10 ENTER MOVIE THEATER 2 TAPE/MD 3 DISCO VCR 6 CHURCH 9 +TEST 100 CLEAR A/B/C/D/E POWER STANDBY DVDMENU Flashes twice. * If the indicator does not flash, repeat step 4 and enter the code again. 5 Try operating the component with the remote controller to check the code entering is successful. Note If the component cannot be controlled, enter another code for the same manufacturer. 67