Yamaha Rio1608-D2 Rio3224-D2/Rio1608-D2 Owners Manual [English] - Page 24
Other functions, Panel lock
View all Yamaha Rio1608-D2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Display Operations Other functions Initializing to the factory-set state If you turn on the power while holding down both the (DEC) button and (INC) button, you can enter a mode that returns this unit's settings to their factory-set state. This is the same as if you use the SETUP menu to select INITIALIZE → FACTORY PRESET. Initializing the HA parameters If you turn on the power while holding down only the (DEC) button, you will enter a mode that returns the HA parameter values to their factory-set state. This is the same as if you use the SETUP menu to select INITIALIZE → HA PARAMETERS. Initializing the Dante parameters If you turn on the power while holding down only the (INC) button, you will enter a mode that returns the Dante parameter values to their factory-set state. This is the same as if you use the SETUP menu to select INITIALIZE → DANTE SETTINGS. Factory-set initial values The following table shows the factory-set initial values. Parameter Initial value SETUP HA Parameters DANTE Settings UNIT ID START UP MODE SECONDARY PORT FAN SPEED NETWORK MODE IP ADDRESS SUBNET MASK DEFAULT GW DIMMER ERROR MESSAGE BRIGHTNESS HA GAIN +48V HPF GAIN COMPENSATION Sample Rate Latency Encoding Dante Redundancy IP Address Device Label Channel Label AES67 Mode Device Lock Y001 REFRESH DAISY CHAIN LOW AUTO (determined by DHCP or link local) (determined by DHCP or link local) (determined by DHCP or link local) 3 min LIGHT OFF 70% -6 dB Off Off, 80.0 Hz Off, -6 dB 96 kHz (slave), Pull-up/down = None *1 1.0 ms PCM 24 bit Switched (depends on the setting of SETUP SECONDARY PORT) Auto Y001-Yamaha-Rio3224-D2-nnnnnn *2 Y001-Yamaha-Rio1608-D2-nnnnnn *2 Disabled Unlock *1 The default setting of the Sample Rate is 96 kHz. Please be careful when using Rio-D2 in combination with devices which do not support 96 kHz (such as CL or QL series). *2 nnnnnn is the lowest six digits of the Dante Primary MAC Address. Panel lock While this unit is operating, you can put it in the panel lock state by simultaneously holding down the (DEC) button, (INC) button, and the encoder with switch for approximately three seconds. This state is maintained even if the unit is power-cycled. To defeat the panel lock state, simultaneously hold down the (DEC) button, (INC) button, and the encoder with switch once again for approximately three seconds. Brightness adjustment While this unit is operating, simultaneously hold down the (DEC) button and (INC) button for at least 1.5 seconds, and turn the encoder with switch to adjust the brightness of the display (BRIGHTNESS). 24 Owner's Manual