Yamaha SY85 Owner's Manual (feature Reference) (image) - Page 19
Note Limit - keyboard
View all Yamaha SY85 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
5: NOTE LIMIT [PERFORMANCE] → [EDIT] → [MENU] → 1:Layer → [ENTER/YES] → [ENTER/YES] → → [MENU] → 5:Note Limit → [ENTER/YES] The low and high note limit parameters make it possible to create a range of split keyboard effects using the performance layers. You could have two layers on either side of a single split point, a four-way split keyboard, or any other possible combination. LAYER`NoteLimit`)Lo(``````ABCD ``C≥`ø`G8```C≥`ø`G8```C≥`ø`G8```C≥`ø`G8 F1 F2 F3 F4 F5 F6 F7 F8 CS1 CS2 CS3 CS4 CS5 CS6 CS7 CS8 The name of the currently selected voice/layer is shown in the upper right corner of the display. The characters "ABCD" to the right of the voice name indicate the status of each voice: a capital letter if the voice is on, a lower-case letter if the voice is muted, and a dash if the voice is off. Lo (Low note limit) Range: C-2 ... G8 Controls: [CS1], [CS3], [CS5], [CS7], [-1] [+1], Dial, [SHIFT]+keyboard Individually sets the low note limit for each active layer (the lowest note that each layer will produce). Use the [CS1], [CS3], [CS5], and [CS7] sliders to set the low note limits of the A, B, C, and D layer voices, respectively. It is also possible to press the desired note on the keyboard while holding the [SHIFT] key. The C-2 to G8 range of this parameter covers a full 10-1/2 octaves. "C3" corresponds to "middle C" on a keyboard. This parameter, in conjunction with the High Note Limit parameter described below, allows the sound from a layer to be limited to a specific region of the keyboard. If the Low Note Limit is set to C3 and the High Note Limit for the same layer is set to C4, for example, the sound from that layer will only be produced between C3 and C4 - the octave immediately above middle C. This makes it simple to produce split voices. If the High Note Limit is set to a note that is lower than the Low Note Limit for the same layer, the notes between the high and low limits will not sound. Voices that are turned off are indicated by "---" on the display. 18 PERFORMANCE EDIT MODE / 1:Layer