Yamaha TX6n Owner's Manual - Page 10

Basic Operation of the TXn Operations that can be Performed from the Panel NOTE • For details, refer to the TX6n/5n/4n Reference Manual. Category Subcategory Explanation METER ANA INPUT VOLTAGE Shows the input level from the analog input connectors. SLOT INPUT VOLTAGE Shows the input level from the slot. SP OUTPUT VOLTAGE Shows the output level from the [SPEAKERS] connectors. SP OUTPUT POWER Shows the output power from the [SPEAKERS] connectors. SP OUTPUT IMPEDANCE Shows the output impedance from the [SPEAKERS] connectors. SLOT OUTPUT METER Shows the output level to the slot. THERMAL Shows the heat sink temperature. UTILITY Device Setup Makes settings to distinguish the amplifier on a network. Word Clock Setup Sets the word clock. Information Shows information about the amplifier. Network Setup Specifies the IP address and other settings for using the amplifier in a network. LCD Setup Specifies the display settings. Front Panel Operation Turns panel operation lock on/off. Scene Setup Makes scene* settings. Misc Setup Sets the amplifier's internal clock, etc. MENU General Sensitivity/Amp Gain Sets the input sensitivity/gain. Stereo/Bridge/Parallel Specifies the amplifier's mode (Stereo/Bridge/Parallel). Attenation Link Specifies whether attenuator operation will be linked between channels A and B. Input Redundancy Specifies the redundant connection mode, etc. Signal Path Makes settings for the equalizer, delay, crossover, and others that process the audio signal. Speaker Processor libraries can also be recalled. Signal Chain Analog Input Signal Chain Makes settings for checking whether the audio signal is being correctly input from the analog connectors. Slot Input Signal Chain Makes settings for checking whether the audio signal is being correctly input from the slot. Output Signal Chain Makes settings for checking the status of output from the [SPEAKERS] connectors. Calibration Calibrate by Pilot Tone Uses a pilot tone to measure the impedance of the connected speakers. Calibrate by Program Source Uses an audio signal to measure the impedance of the connected speakers. Limiter Voltage Limiter Makes settings for the limiter. Power Limiter Limiter Gain Reduction Specifies whether the limiter will be linked between channels A and B. SCENE Recall Recalls a scene*. Store Stores a scene*. Edit Edits a scene*. Clear Clears a scene*. *Scene..........The settings listed above, such as power Standby/On or mute (with the exception of UTILITY), are called a "scene". By recalling a scene, the saved settings can be immediately applied to the amplifiers. 10 TX6n/5n/4n Owner's Manual