Yamaha TX6n Owner's Manual - Page 12

Audio I/O Settings Bridge Mode The amplifier will operate as a monaural high-power amp, with the input signal of channel A (analog) or channel 1 (digital) as the source. 5-way binding post connectors - 2. Use the encoder A to move the cursor (the blink- ing frame) to "General," and press the [ENTER] button. 3. Use the function buttons (PREV/NEXT) to access Stereo/Bridge/Parallel screen. + Total speaker impedance: 4-16Ω Digital input Speakon connectors Analog input 4. Use the encoder B to select the desired mode, and press the [ENTER] button to confirm. Gain Setting Set the amplifier gain. 1. Follow the steps 1 and 2 of the above "Mode Setting" to select "MENU" → "General." 2. Use the function buttons (PREV/NEXT) to access the Sensitivity/Amp Gain screen. Total speaker impedance: 4-16Ω Digital input Analog input NOTE • Each of 5-way binding post connectors and Speakon connectors are internally parallel-connected. When using both connectors simultaneously, total speaker impedance of each connector must be 8-32 Ω. Mode Setting Select the power amp mode according to the type of connections you've made. 1. Press the [HOME] button to access the HOME screen, and press the third function button from the left (MENU) to access the MENU screen. 12 TX6n/5n/4n Owner's Manual 3. Use encoder A to move the cursor to Amp Gain or Sensitivity, and encoder B to edit the parameter value. 4. If the parameter value is blinking, press the [ENTER] button to confirm the value. NOTE • Refer to the TX6n/5n/4n Reference Manual for details on the gain. Word Clock Setting If you want to input or output digital audio signals, you must check the word clock settings as necessary. Refer to the TX6n/5n/4n Reference Manual for details on how to check these settings. The factory setting is "Auto Scan Mode: ON."