Yamaha TX6n Owner's Manual - Page 8
Firmware Updates, Preparation - txn 6 amp
View all Yamaha TX6n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Firmware Updates The firmware version of the TXn itself can be checked from the TXn's panel and from Amp Editor. You can update the firmware via Amp Editor. For the update procedure, refer to the Amp Editor Owner's Manual. You can download the latest firmware from the "Downloads" page on the following website. http://www.yamahaproaudio.com/ Preparation [MUTE] buttons [POWER] switch Function buttons [ENTER] button [HOME] button Connecting the AC Power Cable • Be sure to turn all devices OFF before connecting AC mains power. CAUTION Insert the plug into an AC outlet. Be sure to use an AC outlet of the voltage specified for the device. Turning the Power on and off • To prevent the initial power-on surge from generating a large noise spike or damaging your CAUTION speaker system, turn the devices on in the following order: audio sources, mixer (such as M7CL or PM5D), and finally power amplifiers. Reverse this order when turning power off. 1. Press the front panel [POWER] switch to the "ON" position to turn the power on. 2. Press the [POWER] switch to the "OFF" position to turn off the power. NOTE • The settings at the time you powered-off are remembered. When you turn on the power to the TXn, it will start up with the same settings. You can use the "Last Mem. Resume" setting to set up the TXn so that at startup it will recall the scene number selected before you turned off the power to the device. • Do not turn off the power while the upper part of the display indicates "Do Not Turn Off!" Other- CAUTION wise, a malfunction may occur. • A small amount of current is flowing even when the power switch is off. If you will not be using CAUTION this device for an extended period of time, be sure to disconnect the power plug from the AC outlet. Switching the Power Status between Standby and On 1. Hold down the panel [HOME] button for at least three seconds. The TXn's display will show the HOME screen, and then a message of "Turning power on: Are you sure?" or "Going Standby: Are you sure?" will appear. 2. Press the panel [ENTER] button, and the power status will switch between Standby and On. NOTE • Standby is a state in which the speaker output's power amp section is off (operation other than speaker output will continue). Switching Mute on/off Hold down the [MUTE] button of the channel you want to mute for at least one second. The channel's output will be muted, and the [MUTE] indicator will light. To switch mute off, press the [MUTE] button again for at least one second. 8 TX6n/5n/4n Owner's Manual