Yamaha V5.1 CL/QL Series V5.1 Supplementary Manual [English] - Page 4
I/O DEVICE HA window, For Stagetec NEXUSXDIP, Remote control settings
View all Yamaha V5.1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
I/O DEVICE HA window This screen is displayed when you select the desired I/O device in the I/O DEVICE screen (I/O page). You can remotely control the head amp of the I/O device. For Stagetec NEXUS(XDIP) 1 2 3 1 +48V button These switch phantom power on/off for each channel. 2 GAIN knob Indicates the gain of the head amp on the I/O device. To adjust the value, press the knob to select it, and use the multifunction knobs (CL series) or the TOUCH AND TURN knob (QL series). NOTE For devices with a wider setting range than the CL/QL series, since some values cannot be set from the CL/QL series. Likewise, if the value set on the connected device side is outside the CL/ QL series setting range, it will be displayed as an approximate value or limit value. 3 FREQUENCY knob/HPF button These controllers switch on or off the high-pass filter built into the head amp of the I/O device, and adjust its cutoff frequency. If you press the FREQUENCY knob to select it, you will be able to adjust it using the corresponding multifunction knob (CL series) or the TOUCH AND TURN knob (QL series). NOTE For devices that differ in how the setting value changes from the CL/QL series, the cutoff frequency will be set as an approximate value. I/O devices and external head amps Remote control settings • MTX/MRX series The following settings are necessary to control the MTX/MRX series remotely. STEP 1. Install the MTX-MRX Editor on the computer. 2. Connect the MTX-MRX series and Editor according to the MTX-MRX Editor user guide. 3. Set remote (RS-232C) BIT RATE: 38400 in the System menu, Remote Control dialog of the MTX-MRX Editor. 4. Match the subnet of the CL/QL series on the NETWORK screen (FOR DEVICE CONTROL page) with the subnet of MTX-MRX series. 5. Place the ANALOG IN component using the MRX Designer, since the MRX Series components can be freely placed therein. • Stagetec NEXUS(XDIP) Network configuration is required to control NEXUS(XDIP) remote. For details, please contact the Stagetec Company, or refer to the website of the Stagetec Company. Also, in order to validate the remote control setting contents from the CL/QL series, NEXUS must be used to properly set the internal routing of XDIP. 4 V5.1 Supplementary Manual