Yamaha V740 Owners Manual - Page 59

Changing parameter settings You can enjoy high quality sound with the factory-set parameters. Although you do not have to change the initial settings, you can change some of the parameters to better suit the input source or your listening room. Use the remote control to make adjustments. y • It is advisable to use on-screen display when changing the settings. POWER TV REC DISC SKIP POWER AV AMP AUDIO VOL LEVEL TITLE TV INPUT TV VOL SET MENU MENU A/B/C/D/E MUTE CH TV MUTE CH SELECT PRESET TEST RETURN HALL 1 TV VOL JAZZ CLUB 2 PRESET ON SCREEN DISPLAY ROCK CONCERT 3 STEREO EFFECT ENTERTAINMENT 4 MUSIC VIDEO 5 TV THEATER 6 MOVIE MOVIE THEATER 1 THEATER 2 7 8 /DTS SUR. 9 10 0 NIGHT 11 +10 6.1/5.1 12 CHP/INDEX 1 5 4 2 3 1 Press AMP to set the AMP remote control in AMP mode. 2 Turn on the video monitor and press ON SCREEN repeatedly to select the full display mode. ON SCREEN DISPLAY 3 Select a DSP program you want to adjust. HALL 1 MUSIC VIDEO 5 JAZZ CLUB 2 ROCK CONCERT 3 ENTERTAINMENT 4 TV THEATER 6 MOVIE MOVIE THEATER 1 THEATER 2 7 8 /DTS SUR. 9 10 0 NIGHT 11 +10 6.1/5.1 12 CHP/INDEX SOUND FIELD PROGRAM PARAMETER EDITING 4 Press u / d to select the + parameter. TV VOL CH - PRESET TV MUTE SELECT TV VOL - CH + PRESET 5 Press j / i to change the + parameter value. TV VOL CH - PRESET TV MUTE SELECT TV VOL - CH + PRESET y • When you set the parameter to a value other than the factoryset value, an asterisk mark (*) appears by the parameter name on the video monitor. To reset to the factory-set value, press j / i repeatedly until the asterisk mark disappears. 6 Repeat steps 3 to 5 above as necessary to change other program parameters. Notes • For some of the programs, the available parameters may be displayed on more than one OSD page. To scroll through pages, press u / d. • You cannot change parameter values when "OPTION 2 MEM. GUARD" on the set menu is set to ON. Memory back-up The memory back-up circuit prevents the stored data from being lost even if this unit is set in standby mode, the power cord is disconnected from the AC outlet, or the power supply is temporarily cut due to power failure. However, if the power is cut for more than one week, the parameter value you edited will return to the factory setting. If this happens, edit the parameter value again. Program No. Program name Cursor P03 ROCK CONCERT ≥ DSP LEVEL............0dB INIT.DLY............15ms ROOM SIZE............1.0 LIVENESS 5 REV.TIME............1.6s REV.DELAY......120ms Parameters Parameter values The parameter setting display ADDITIONAL INFORMATION English 55