Yamaha XDA-QS5400 XDA-QS5400 Owner s Manual - Page 5
Rear panel, CUT IN : IN SENSING/THRU. OUT jacks
View all Yamaha XDA-QS5400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Rear panel ab cd e f g h i a GND screw terminal Connecting the source device chassis to the GND terminal of the unit may reduce noise in the signal. Note The ground is not a safety ground. b ETHERNET jacks Connection: RJ-45 For a wired connection to a network. Using an ETHERNET jack, connect the unit to your router with an Ethernet cable. Using another ETHERNET jack, you can connect the unit to another network device (such as another XDA-QS5400) in cascade. Notice The unit is equipped with an Ethernet hub (Layer-2 Ethernet switch) internally. Do not connect both ETHERNET jacks to the same router. In that case, a routing loop might interfere with communication of the whole network. c IR IN/OUT jack Connection: 3.5 mm monaural mini-plug For connecting to an external remote control device and inputting/outputting remote control signals. The output with passthrough function is enabled even in standby mode. d CUT IN : IN (SENSING)/THRU. OUT jacks Connection: stereo RCA plug (L/R) IN (SENSING): For connecting to a paging system or another audio device. The audio signals cut in or fade in the playback in each ZONE. THRU. OUT: For outputting analog audio signals input in IN (SENSING) jacks by pass-through function. The output is enabled even in standby mode. e AUX : IN/THRU. OUT jacks Connection: stereo RCA plug (L/R) IN: For connecting to an audio playback device such as a CD player (analog out jack) and inputting audio signals. You can play back music from an audio playback device when you select "AUX" as the input source. THRU. OUT: For outputting analog audio signals input in AUX : IN jacks by pass-through function. The output is enabled even in standby mode. j k f PRE OUT/ZONE1- 4 jacks Connection: stereo RCA plug (L/R) For connecting to external power amplifiers and outputting audio signals in ZONE1 - ZONE4. g CHIME (CONTACT CLOSURE) 1- 4 jacks Connection: 3.5 mm monaural mini-plug (Tip: + / Sleeve: -) For connecting to contact closures such as door bells. When the contact closure is closed (+ and - of the jack is shorted), the preset chime sounds in the selected ZONE. h TRIGGER OUT 1- 4 jacks Connection: 3.5 mm monaural mini-plug (Tip: + / Sleeve: -) For outputting trigger signals (DC 12 V). In general, the output level is "High" when the unit is powered on or "Low" in standby mode. i NORMAL/BRIDGE switch Selects NORMAL/BRIDGE connection of speakers. This switch is normally set to NORMAL. Change the setting to BRIDGE only when the speaker is used in bridge connection. Note Unplug the unit's power cord from the AC wall outlet before changing the NORMAL/BRIDGE switch setting. j SPEAKERS terminals Connection: Euroblock connectors (supplied) Speaker impedance: 4 Ω or over (NORMAL), 8 Ω or over (BRIDGE) For connecting to speakers with supplied Euroblock connectors. k AC IN jack For connecting the supplied power cord. EN En 5