Yamaha YAS-101 Owners Manual - Page 17
Problem, Cause, Solution - shuts off
View all Yamaha YAS-101 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
English Troubleshooting Problem Cause Solution The volume, subwoofer and The adjustment has reached the maximum or audio delay time is not minimum. adjustable. The unit does not learn the operation of TV remote control. The remote control sensor of the unit may be exposed to direct sunlight or lighting. The screen glare of TV disturbs the remote control signal. Reposition the unit. Disconnect the power cable and perform the remote control learning operation again. The batteries of TV remote control may be worn Replace the batteries. out. The button of the unit was not pressed long enough for the remote control learning operation. Press the button of TV remote control in the order "press 1 second" → "release 1 second" → "press 1 second" The TV remote control is not available for remote control learning. Use the remote control of the unit. The TV remote control is outside of the operation range. Point your TV remote control towards the remote control sensor of the unit keeping a distance of 30 cm (1 ft) between them. The unit does not enter the remote control learning mode. Operate after checking that the INPUT indicator is flashing in red. The power state of the unit and of your TV is opposite. (For example, though your TV is on, the unit is in standby mode.) The power state of the unit and of your TV is opposite from the beginning. Press the power button of TV remote control to set your TV and the unit to standby mode after pressing the power button of your TV itself and of the unit to set both your TV and the unit to on. The TV remote control is not working even if you use the TV remote control signal transmission function. The unit and TV are too close/far from one another. Try to use the TV remote control signal transmission function again after repositioning the IR flasher of the unit and the remote control sensor of your TV. Try to use the TV remote control signal transmission function again after adjusting the height of the unit by removing or attaching its stands. Something is between the unit and your TV. Remove the obstruction. The TV remote control signal transmission function is not activated. Restart the unit and check the indicator status. The TV remote control is not compatible with Place the unit (without the stands, for example) the TV remote control signal transmission so as not to hide the remote control sensor of function. your TV. You cannot use 3D glasses. The unit obstructs the 3D glasses transmitter of your TV. Check the position of 3D glasses transmitter of your TV by referring to the manual of your TV, and move the unit to the position where there is no obstruction. The picture on your TV The unit is too close to your CRT TV. screen becomes blurred or distorted. Move the unit away from your TV. Contact your nearest authorized Yamaha dealer or service center if the following problem occurs. Problem Cause Solution The power of the unit The protection circuit is activated. immediately shuts off, and the INPUT indicator flashes. See page 8 - - - 9 9 9 9 9 9 9 - 9 9 - - See page - 13 En