Yamaha YHT-22 Quick Connection Guide - Page 10
Rogramming, Emote, Ontrol - home theater
View all Yamaha YHT-22 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
YHT-22 QUICK-CON N ECT GUIDE PROGRAMMING THE RAV200 REMOTE CONTROL Indicator LED Use Keypad To Enter Setup Codes Component Selector Buttons Turns On Component's Power SETTING UP COMPONENTS Perform the procedure for each component you own. At the end of each step 5, the remote control's processor will automatically assign the selected component's control functions to its own buttons, ready for your use. SETTING UP YOUR TV 1. Turn on the television set and look up a setup code for your brand of television (see pages 113 and 114 of the HTR-5140 Owner's Manual). 2. On the RAV200, press TV. Use To Enter Setup Mode Use To Enter Setup Mode 3. Press and hold both VOLUME buttons at least four seconds until the indicator LED flashes twice. The YHT-22 Home Theater package includes the RAV200 pre-programmed remote control with factory codes to control your HTR-5140 receiver and most Yamaha audio components. To program other brands of components (i.e., TV, VCR, etc.) or if your Yamaha unit does not respond, you will need to program the remote control with the manufacturer's codes (listed on pages 113 through 117 of the HTR-5140 Owner's Manual). NOTE: The RAV200 is designed to control most major brands of audio and video components. For other units, use the original remote control supplied with the product. POWER ON 1. Load the supplied batteries into the RAV200. 2. Aim the remote control at the HTR-5140, press AMP/TUNER, and then press POWER. 3. The receiver should turn on. 4. Using the keypad, enter the four-digit setup code. The indicator LED will flash twice after your entry. If the LED did not flash twice, repeat steps 3 and 4. 5. To verify the code works, aim the RAV200 at the television set, press TV, and then press POWER. The television set should turn off. If it doesn't respond, use another code for the same manufacturer and repeat steps 3 through 5. 10