Yamaha YHT-22 Quick Connection Guide - Page 11

YHT-22 QUICK-CON N ECT GUIDE PROGRAMMING THE RAV200 REMOTE CONTROL (CONTINUED) SETTING UP YOUR CABLE BOX (OR DSS) 1. Turn on the cable box (or DSS) and look up a setup code for your brand of cable box (or DSS) - see pages 114 and 115 of the HTR-5140 Owner's Manual. 2. On the RAV200, press CBL/DBS. SETTING UP YOUR DVD (OR LD) PLAYER 1. Turn on the DVD (or LD) player and look up a setup code for your brand of DVD (or LD) player (see page 116 of the HTR-5140 Owner's Manual). 2. On the RAV200, press DVD/LD. 3. Press and hold both VOLUME buttons at least four seconds until the indicator LED flashes twice. 4. Using the keypad, enter the four-digit setup code. The indicator LED will flash twice after your entry. If the LED did not flash twice, repeat steps 3 and 4. 5. To verify the code works, aim the RAV200 at the cable box (or DSS), press CBL/DBS, and then press POWER. The unit should turn off. If it doesn't respond, use another code for the same manufacturer and repeat steps 3 through 5. SETTING UP YOUR VCR 1. Turn on the VCR and look up a setup code for your brand of VCR (see pages 115 and 116 of the HTR5140 Owner's Manual). 2. On the RAV200, press VCR. 3. Press and hold both VOLUME buttons at least four seconds until the indicator LED flashes twice. 4. Using the keypad, enter the four-digit setup code. The indicator LED will flash twice after your entry. If the LED did not flash twice, repeat steps 3 and 4. 5. To verify the code works, aim the RAV200 at the VCR, press VCR, and then press POWER. The VCR should turn off. If it doesn't respond, use another code for the same manufacturer and repeat steps 3 through 5. 3. Press and hold both VOLUME buttons at least four seconds until the indicator LED flashes twice. 4. Using the keypad, enter the four-digit setup code. The indicator LED will flash twice after your entry. If the LED did not flash twice, repeat steps 3 and 4. 5. To verify the code works, aim the RAV200 at the DVD (or LD) player, press DVD/LD, and then press POWER. The unit should turn off. If it doesn't respond, use another code for the same manufacturer and repeat steps 3 through 5. SETTING UP OTHER COMPONENTS 1. Turn on the component (e.g., CD player, tape deck, or MD player) and look up a setup code for your brand of component (see pages 113 through 117 of the HTR-5140 Owner's Manual). 2. On the RAV200, press the desired component button (e.g., CD or TAPE/MD). 3. Press and hold both VOLUME buttons at least four seconds until the indicator LED flashes twice. 4. Using the keypad, enter the four-digit setup code. The indicator LED will flash twice after your entry. If the LED did not flash twice, repeat steps 3 and 4. 5. To verify the code works, aim the RAV200 at the component, press the appropiate component button, and then press POWER. The unit should turn off. If it doesn't respond, use another code for the same manufacturer and repeat steps 3 through 5. 11