Yamaha YID-W10 Owners Manual - Page 6

3: Playback 1 Connect your iPod/iPhone to the transmitter. The green LED on the transmitter (YIT-W11TX) and blue LED on the receiver (YIR-W10) light up if a wireless connection between the transmitter and receiver is established. 2 Start playback on your iPod/iPhone. Operation and function depend on your iPod/ iPhone model and Yamaha component. Refer to the owner's manuals supplied with your iPod/ iPhone and Yamaha component. Notes • In case noises are output from the speaker, place the receiver away from your Yamaha component. • The transmitter is powered by the battery of your iPod/iPhone. When your battery of iPod/iPhone becomes empty, charge your iPod/iPhone. Status LED y • The transmitter stops wireless communication automatically after a short time you stop iPod/ iPhone playback. • To disconnect the iPod/iPhone from the transmitter, pull it upward. Status LED Transmitter LED status LED Status Lights up green Wireless communication between the transmitter and receiver is established. Flashes green once Adjusting the volume level. Flashes green continuously Connection in progress, please wait. Flashes red once The volume of Yamaha component is set to maximum or minimum. Flashes red for 2 seconds An unsupported iPod is connected. Flashes red continuously Error occurs. Remove the iPod/iPhone from the transmitter, and connect again. Flashes red 2 times continuously The battery of the iPod/iPhone is low. Off An iPod/iPhone is not connected or wireless communication has not been established. Receiver LED status LED Lights up blue Flashes blue once Flashes blue Flashes blue rapidly Off Status Wireless communication between the transmitter and receiver is established. Adjusting the volume level. Connection in progress, please wait. Error occurs. The receiver is in need of repair. An iPod/iPhone is not connected or wireless communication has not been established. 4 En