Yamaha YST-SW40 Owner's Manual - Page 9

English Front panel CONTROLS AND THEIR FUNCTIONS POWER HIGH CUT VOLUME 40 Hz 140 Hz 0 10 POWER HIGH CUT VOLUME 50 Hz 150 Hz 0 10 12 3 4 Rear panel OUTPUT TO SPEAKERS INPUT2 AUTO POWER FROM AMPLIFIER INPUT1 ON OFF OUTPUT TO SPEAKERS INPUT2 AUTO POWER FROM AMPLIFIER INPUT1 ON OFF 5 1 POWER indicator Lights up when the POWER switch is turned ON, and goes off when turned OFF. * If the AUTO POWER ON/OFF switch on the rear panel is set to ON, this indicator is illuminated dimly when no signal is input to this unit. 2 POWER switch Turns the power of this unit ON and OFF whenever pressed. When this switch is turned ON, the indicator on the left of the POWER switch lights up. 3 HIGH CUT control Adjusts the high frequency cut off point. Frequencies higher than the frequency selected by this control are all cut off (and not output). * One graduation of this control represents 10 Hz. I00 90 80 II0 I20 70 60 50 Hz I30 I40 I50 Hz 4 VOLUME control Adjusts the volume level. 5 AUTO POWER ON/OFF switch By setting this switch to the ON position, this unit's automatic power ON/OFF function operates as described below. If you do not need this function, set to the OFF position. * Make sure to change the setting of this switch only when the power of this unit is off. Automatic power ON/OFF function When you play a source, the power to this unit turns on automatically by sensing audio signals input to this unit. The power turns off automatically if the source being played is stopped or the input signal is cut off for several minutes. * This function will operate responding to a certain level of input signal. Increase the output level on the input source if the automatic power ON function will not operate, or decrease the level if the automatic power OFF function will not operate. * There may be a case that the power turns on unexpectedly by sensing noise from other appliances. If it occurs, set the AUTO POWER ON/OFF switch to the OFF position. This function is available only when the power of this unit is on (by setting the POWER switch (2) to "on"). 9