Yamaha YST-SW45 Owner's Manual - Page 7

English Using two units Disconnect your main speakers from the amplifier if connected, and connect them to the speaker terminals of this unit. Right speaker Left speaker This unit OUTPUT TO SPEAKERS INPUT2 AUTO STANDBY FROM AMPLIFIER INPUT1 LOW HIGH OFF POWER ON OFF OUTPUT TO SPEAKERS INPUT2 AUTO STANDBY FROM AMPLIFIER INPUT1 LOW HIGH OFF To AC outlet Speaker terminals OUTPUT TO SPEAKERS FROM AMPLIFIER INPUT1 INPUT2 AUTO STANDBY LOW HIGH OFF This unit OUTPUT TO SPEAKERS INPUT2 AUTO STANDBY FROM AMPLIFIER INPUT1 LOW HIGH OFF Amplifier POWER ON OFF To AC outlet Connecting to this unit's OUTPUT/INPUT terminals For connections, keep the speaker wires as short as possible. (Cut the excessive wire, if necessary.) If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, by observing + and - markings. If these wires are reversed, the sound will be unnatural and will lack bass. Do not let the core of the speaker wires touch each other and do not let them touch the metal parts of this unit as this could damage this unit, your amplifier and/or speakers. * Banana Plug connections are also possible (except for U.K. and Europe models). Simply insert the Banana Plug connector into the corresponding terminal. How to Connect: Red: positive (+) Black: negative (-) 1 Unscrew the knob. 2 Insert the core of the wire. [Remove approx. 5 mm (1/4") insulation from the speaker wires.] 3 Tighten the knob to secure the wire firmly. 7