Yamaha YST-SW500 Owner's Manual - Page 12

Storing preset data of the VOLUME control etc. You can store preset data of the VOLUME control, the HIGH CUT control and the PHASE switch as a set. Each of the three PRESET keys on the remote control transmitter is used to store (and recall) one set of data. With this function, you can recall any preset data easily according to the source. 1 POWER CODE I2 ON/OFF NOM/REV OUTPUT PHASE PRESET MEMORY 2 3 UP UP DOWN DOWN HIGH-CUT VOLUME Active Servo Technology REMOTE CONTROL TRANSMITTER 2 3 1PRE2SET3 PHASEOUTPUT POWER HIGH40CHUzT I40VHOzLUM0E I0 1PRE2S,,,,,,ET3 PH,,,,,,ASE O,,,,,,UTPUT,,,,,,,,,,,,POWER,,,,,,,,,,,,HIGH4,,,,,,0CHUzT ,,,,,,I40VHOz,,,,,,LUM0E ,,,,,,I0 ,,,,,, 1 To store 1 Adjust the VOLUME control, the HIGH CUT control and the PHASE switch. 2 Press the MEMORY key. The PRESET number indicators on the front panel flash. 3 Press the PRESET 1 key. The corresponding PRESET number indicator illuminates. This shows that the data has been stored in PRESET 1. * In the same way, store other sets of data in PRESET 2 and 3. To recall Simply press the PRESET (1, 2 or 3) key where the data you want to recall is stored. Notes • A new setting can be stored in place of the former one. • While the VOLUME control or the HIGH CUT control is rotating from a PRESET key having been pressed, pressing another PRESET key is ineffective. Memory back-up The memory back-up circuit prevents the stored data from being lost even if the POWER switch is set off or the power plug is disconnected from the AC outlet or the power is cut due to temporary power failure. If, however, the power is lost for more than two weeks, the memory may be erased. If so, it can be re-stored by simply following the steps described above. 12