Yamaha YST-SW500 Owner's Manual - Page 9

1 PRESET number indicator The number corresponding to the selected PRESET key illuminates. 2 OUTPUT indicator Illuminates when the OUTPUT switch is turned ON, and goes off when turned OFF. 3 POWER switch Turns the power on/off. 4 VOLUME control Adjusts the volume level. For easier operation, use the VOLUME UP/DOWN keys on the remote control transmitter. 9 OUTPUT switch Turns the output of this unit ON and OFF whenever pressed. When this switch is turned ON, the OUTPUT indicator on the front panel illuminates. 0 PHASE switch Normally this switch is to be set to the normal (NOM) position. However, according to your speaker systems or the listening condition, there may be a case when better sound quality is obtained by setting this switch to the reverse (REV) position. Select the better position by monitoring the sound. In the normal position, the PHASE indicator on the front panel illuminates in red, and in the reverse position, it illuminates in green. 5 PHASE indicator Illuminates in red when the PHASE switch is in the normal (NOM) position, and illuminates in green when in the reverse (REV) position. A MEMORY key/PRESET keys Used to store and recall the data for the VOLUME control, the HIGH CUT control and the PHASE switch adjustments. (See page 12.) 6 Remote control sensor Receives the signals from the remote control transmitter. 7 HIGH CUT control Adjusts the high frequency cut off point. Frequencies higher than the level set by this control are all cut off (and not output). For easier operation, use the HIGH-CUT 90 70 100 UP/DOWN keys on the remote control 70 110 transmitter. 60 120 * One graduation of this control indicates 50 10 Hz.130 40 Hz 140 Hz 8 (REMOTE) CODE switch Switches the signal codes for remote control. Set both the CODE switches on the remote control transmitter and the rear panel of the unit(s) according to the usage of the unit(s) referring to the following descriptions. If using one YST-SW500; Set both the CODE switches on the remote control transmitter and the rear panel to the 1 position, and the unit can be controlled by the remote control transmitter. If using two YST-SW500s; • If you will control two units at the same time with the remote control transmitter, set the CODE switches on the remote control transmitter and the rear panels of the two units to the 1 position. • If you will control two units individually with the remote control transmitter, set the CODE switch on the rear panel of one unit to the 1 position and the other to the 2 position. When you control one unit with the remote control transmitter, switch the CODE switch on the remote control transmitter to the corresponding position. 9