Zanussi Z716WT83BI User Manual - Page 29
Daily Use - Washing & Drying
View all Zanussi Z716WT83BI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
END OF THE PROGRAMME When the programme has finished, the appliance stops automatically. The acoustic signals operate (if they are active). The display shows The indicator of the Start/Pause off. button goes The door unlocks and the indicator goes off. 1. Press button On/Off to deactivate the appliance. After five minutes from the end of the programme, the energy saving function automatically deactivates the appliance. When you activate the appliance again, the display shows the end of the previous programme. Turn the programme dial to set a new cycle. 2. Remove the laundry from the appliance. 3. Make sure that the drum is empty. 4. Keep the door and the detergent dispenser slightly ajar to prevent mildew and odours. 5. Close the water tap. DRAINING WATER OUT AFTER END OF CYCLE If you have chosen a programme or an option that does not empty out the water of the last rinse, the programme is completed, but: • The time area shows and the display shows the door locked . • The indicator of the Start/Pause button starts flashing. • The drum still turns at regular intervals to prevent creases in the laundry. • The door stays locked. • You must drain the water to open the door: DAILY USE - WASHING & DRYING 1. If necessary, touch the Spin button to decrease the spin speed proposed by the appliance. 2. Press the Start/Pause button: the appliance drains the water and spins. The option indicator Rinse Hold disappears. If you have selected No Spin , the appliance will only drain the water. 3. When the programme is completed and the door locked indicator goes off, you can open the door. 4. Press the On/Off button for a few seconds to deactivate the appliance. STAND-BY FUNCTION The Stand-by function automatically deactivates the appliance to reduce the energy consumption when: • You do not use the appliance for 5 minutes when no programme is running. Press the button On/Off to activate the appliance again. • 5 minutes after the end of the washing programme. Press the On/Off button to activate the appliance again. The display shows the end of the last programme. Turn the programme dial to set a new cycle. If the dial is rotated to the "Reset" position , the appliance automatically turns off in 30 seconds. If you set a programme or an option that ends with water in the drum, the Stand-by function doesn't deactivate the appliance to remind you to drain the water. WARNING! Refer to Safety chapters. This appliance is an automatic washer dryer. COMPLETE WASH&DRY PROGRAMME Automatic Non-Stop programme or programmes Depending on the model, the appliance may be equipped with one or more NonStop 60min programmes, automatic wash&dry programmes where it is not necessary to set the Mode - Dry. Proceed as follows: 1. After loading laundry and detergent, press the On/Off button for some seconds to activate the appliance. 29