Zanussi Z816WT85BI User Manual - Page 30
Daily Use - Drying Only
View all Zanussi Z816WT85BI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
2. Set the NonStop 60min programme by means of the programme dial. 3. Touch the Start/Pause programme. button to start the Non-automatic wash&dry programmes In some washing programmes, you can combine Mode - Wash and Mode - Dry for running a complete wash&dry programme. Proceed as follows: 1. Press the On/Off button for some seconds to activate the appliance. 2. Load the laundry one item at a time. 3. Put the detergent and the additives in the appropriate compartment. 4. Turn the programme dial to the washing programme. The appliance defaults to the washing only mode and the indicator of the Mode - Wash button is on. The display shows the default temperature and spin. If necessary, change them according to your laundry. 5. Set the desired options, if there are available. 6. Tap on the Mode button once to activate also the drying function. Both indicators of the Mode - Wash and Mode - Dry buttons are on. The indicator appears on the display. WASHING AND DRYING - AUTOMATIC LEVELS 1. Tap on the Auto Dry button repeatedly until the display shows the required dryness level. The indicators in the display illuminate accordingly: a. Iron dry: for cotton items; b. Cupboard dry: for cotton and synthetic items; c. Extra dry: for cotton items. The time value on the display is the duration of both cycles washing and drying, calculated on a default load size. To have a good drying by using less energy and in a shorter time, the appliance does not let you set a too low spin speed for the items to be washed and dried. DAILY USE - DRYING ONLY 2. Touch button Start/Pause to start the programme. The AutoAdjust estimation starts. In the display the door locked indicator comes on. The display also shows the remaining programme time. WASHING AND TIMED DRYING 1. Tap on the Time Dry button repeatedly to set the desired time value (see the "Timed drying" table the "Programmes" chapter). The drying level indicator goes off and the indicator comes on. Each time you tap on this button the time value increases by 5 minutes. The display shows the set new time value. 2. Touch the Start/Pause button to start the programme. The AutoAdjust estimation starts. In the display the door locked indicator comes on. The display also shows the remaining programme time. AT THE END OF THE DRYING PROGRAMME • The appliance stops automatically. • The acoustic signals operate (if they are active). • In the display comes on. • The indicator of the Start/Pause button goes off. The door locked indicator goes off and the door unlocks. • Press the On/Off button for some seconds to deactivate the appliance. After some minutes from the end of the programme, the energy saving function deactivates the appliance automatically. 1. Remove the laundry from the appliance. 2. Make sure that the drum is empty. After drying phase, clean the drum, the seal and the inside of the door with a wet cloth. WARNING! Refer to Safety chapters. This appliance is an automatic washer dryer. 30