Zanussi ZCE560DW Product Manaul - Page 21
Installation - cooker
View all Zanussi ZCE560DW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Problem The grill, ovens and timer do not work. The grill and top oven work but the main oven does not. The timer does not work. The oven is not cooking evenly. The indicator neons are not working correctly. The oven fan is noisy. The oven temperature is too high or too low. Possible solution • Check that the appliance has been wired in to the appliance supply and is switched on at the wall. • Check that the main appliance fuse is working. • If you have checked the above: Allow the appliance to cool for a couple of hours. The appliance should now be working normally. • Check that the time of day has been set on the clock. • Check that the instructions for the operation of the timer are being closely followed. • Check that the appliance is correctly installed and is level. • Check that the recommended temperatures and shelf positions are being used. • Check that you have selected only the function you require. Ensure all other controls are in the off position. • Check that the oven is level. • Check that the shelves and bakeware are not vibrating in contact with the oven back panel. m • Check that the recommended temperatures and shelf positions are being used. Be prepared to adjust the temperature up or down to achieve the results you want. Installation Installation instructions ! WARNING! This appliance must be earthed. • If your appliance has been damaged in transit, contact your supplier immediately. Do not attempt to install it. • Your appliance left the factory fully packaged to protect it from damage. If it is delivered without packaging and damage has occurred, the manufacturer cannot accept responsibility. Contact your supplier for advice. • Once the packaging has been removed the appliance should only be moved by hand. Do not use a sack barrow or any other aid to lift the appliance as damage may occur. Do not carry the appliances at the doorhandle. • To move the appliance, open the oven door and lift the appliance by holding inside the top of the compartment. • This is a type X appliance, which means it is freestanding and can be fitted with cabinets on one or both sides. • Sidewalls, which are above hob level, should be protected by heat resistant non-combustible material and must not be nearer than 40mm to the hob side. • A nominal air gap of 5mm at either side of the appliance is required to enable the appliance to be moved into position. • Always ensure an air gap is maintained at hotplate level. Tiles or other forms of deep wall covering should not obscure this gap. • Overhanging surfaces or a cooker hood should be a minimum of 685mm above the hob. • It is important to ensure that the appliance is level after installation. Levelling feet are fitted to the appliance to accommodate uneven floors. Adjustment of levelling feet The cooker stands on 4 levelling feet. It is required to confirm the appliance is correctly levelled before 21