Zanussi ZDE67560W Product Manaul - Page 9

Drying cycle complete / removing laundry Once the drying cycle is complete, the lights END and light 6 - FILTER are on. If the buzzer is active, an acoustic signal sounds intermittently for about one minute. The drying cycles are automatically followed by an anti-crease phase which lasts around 30 minutes. The drum rotates at intervals during this phase. This keeps the laundry loose and free of creases. The laundry can be removed at any time during the anti-crease phase. (The laundry should be taken out towards the end of the anti-crease phase at the latest to prevent creases from forming.) Cleaning and maintenance 1. Open door. 2. Remove laundry. 3. Remove filter after clothes has been re- moved. Clean the filter. Warning! Before You place the filter , please check it there is nothing inside the filter seat. 4. Turn the programme selector to OFF . Important! Clean the filter after each drying cycle. 5. Close the door. Warning! The tumble dryer is not to be used if industrial chemicals have been used for cleaning! Warning! You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. Cleaning fluff filter The filter collect all the fluff which accumulates during drying. To ensure that the dryer works perfectly, the fluff filter must be cleaned after every drying cycle. The warning light FILTER , is on to remind you this operation. Caution! Never operate the dryer without fluff filter or with damaged or blocked fluff filter. 1. Open loading door and remove laundry. 2. Remove the filter which is built into the lower part of the loading aperture. 3. Open the filter pressing the button, among two slots on fingers. Clean the filter using dump hand or cloth. After a period of time, a patina due to detergent residue on laundry forms on the filters. When this occurs, clean the filter with warm water using a brush. Close the filter and do not forget to put it back. Warning! Before You place the filter, please check it there is nothing inside the filter seat. 4. The filter can be positioned only to one side. If position is wrong, the filter overhangs. If the filter will not snap into place, the loading door cannot be closed. Cleaning the door Clean periodically the interior part of the door to remove any fluff. Accurate cleaning ensures correct drying. 1) Only dryers with buzzer button www.zanussi.com 9