Zanussi ZGH66424XX User Manual - Page 12

CAUTION! In the absence of electricity you can ignite the burner without electrical device; in this case approach the burner with a flame, turn the control knob counter-clockwise to maximum gas supply position and push it down. Keep the control knob pushed for equal or less than 10 seconds to let the thermocouple warm up. If the burner accidentally goes out, turn the control knob to the off position and try to light the burner again after minimum 1 minute. The spark generator can start automatically when you switch on the mains, after installation or a power cut. It is normal. HINTS AND TIPS WARNING! Refer to Safety chapters. COOKWARE CAUTION! Do not use cast iron pans, clay or earthenware pots, grill or toaster plates. The stainless steel can become tarnished if it is too much heated. WARNING! Do not put the same pan on two burners. WARNING! Do not put unstable or damaged pots on the burner to prevent spills and injuries. CAUTION! Make sure that the bottoms of pots do not stand too close to the control knob, otherwise the flame heats the control knob up. CAUTION! Make sure that pot handles are not above the front edge of the cooktop. The hob is supplied with the progressive valves. They make the flame regulation more precise. TURNING THE BURNER OFF To put the flame out, turn the knob to the off position . WARNING! Always turn the flame down or switch it off before you remove the pans from the burner. CAUTION! Make sure that the pots are placed centrally on the burner in order to get the maximum stability and a lower gas consumption. DIAMETERS OF COOKWARE Use cookware with diameters applicable to the size of burners. Burner Multi Crown Semi-rapid Auxiliary Diameter of cookware (mm) 180 - 260 120 - 220 80 - 180 12