Zanussi ZIFN644K User Manual - Page 15

Problem Possible cause Remedy The heat setting changes between two levels. The sensor fields become hot. comes on. comes on. and a number come on. You can hear a constant beep noise. Power management operates. The cookware is too large or you put it too near to the controls. Child Safety Device or Lock operates. There is no cookware on the zone. The cookware does not cover the cross / square. The cookware is unsuitable. The diameter of the bottom of the cookware is too small for the zone. There is an error in the hob. The electrical connection is incorrect. Refer to "Daily use". Put large cookware on the rear zones, if possible. Refer to "Daily use". Put cookware on the zone. Cover the cross / square fully. Use suitable cookware. Refer to "Hints and tips". Use cookware with correct dimensions. Refer to "Technical data". Deactivate the hob and activate it again after 30 seconds. If comes on again, disconnect the hob from the electrical supply. After 30 seconds, connect the hob again. If the problem continues, speak to an Authorised Service Centre. Disconnect the hob from the electrical supply. Ask a qualified electrician to check the installation. IF YOU CANNOT FIND A SOLUTION... If you cannot find a solution to the problem yourself, contact your dealer or an Authorised Service Centre. Give the data from the rating plate. Give also three digit letter code for the glass ceramic (it is in the corner of the glass surface) and an error message that comes on. Make sure, you operated TECHNICAL DATA the hob correctly. If not the servicing by a service technician or dealer will not be free of charge, also during the warranty period. The instructions about the Service Centre and conditions of guarantee are in the guarantee booklet. RATING PLATE Model ZIFN644K Typ 61 B4A 01 AA Induction 7.35 kW Ser.Nr PNC 949 595 700 00 220 - 240 V / 400 V 2N 50 - 60 Hz Made in Germany 7.35 kW 15