Zanussi ZIT6470CB User Manual - Page 11

TROUBLESHOOTING WARNING! Refer to Safety chapters. WHAT TO DO IF... Problem Possible cause Remedy You cannot activate or operate the hob. An acoustic signal sounds and the hob deactivates. An acoustic signal sounds when the hob is deactivated. The hob deactivates. Residual heat indicator does not come on. Automatic Heat Up does not operate. The heat setting changes between two levels. The sensor fields become hot. The hob is not connected to an electrical supply or it is connected incorrectly. The fuse is blown. You do not set the heat setting for 10 seconds. You touched 2 or more sensor fields at the same time. Pause operates. There is water or fat stains on the control panel. You put something on one or more sensor fields. Check if the hob is correctly connected to the electrical supply. Refer to the connection diagram. Make sure that the fuse is the cause of the malfunction. If the fuse is blown again and again, contact a qualified electrician. Activate the hob again and set the heat setting in less than 10 seconds. Touch only one sensor field. Refer to "Daily use". Clean the control panel. Remove the object from the sensor fields. You put something on the sensor field . The zone is not hot because it operated only for a short time or the sensor is damaged. The zone is hot. The highest heat setting is set. Power management operates. Remove the object from the sensor field. If the zone operated sufficiently long to be hot, speak to an Authorised Service Centre. Let the zone become sufficiently cool. The highest heat setting has the same power as the function. Refer to "Daily use". The cookware is too large or you put it too near to the controls. Put large cookware on the rear zones if possible. 11