Zanussi ZOA35471XK User Manual - Page 22

2. Lift and turn the levers fully on both hinges. 5. Hold the door trim (B) on the top edge of the door at the two sides and push inwards to release the clip seal. 2 B 1 6. Pull the door trim to the front to remove it. 7. Hold the door glass panel by its top edge and carefully pull it out. Make sure the glass slides out of the supports completely. 3. Close the oven door halfway to the first opening position. Then lift and pull forward and remove the door from its seat. 8. Clean the glass panels with water and soap. Dry the glass panels carefully. Do not clean the glass panels in the dishwasher. When the cleaning is completed, install the glass panel and the oven door. The screen-printing zone must face the inner side of the door. Make sure that after the installation the surface of the glass panel frame on the screenprinting zones is not rough when you touch it. When installed correctly the door trim clicks. Make sure that you install the internal glass panel in the seats correctly. A REPLACING THE LAMP WARNING! Risk of electric shock. The lamp can be hot. 4. Put the door on a soft cloth on a stable surface. 1. Turn off the oven. Wait until the oven is cooled down. 2. Disconnect the oven from the mains. 3. Put a cloth on the bottom of the cavity. 22