Zanussi ZRB35315WA Product Manaul - Page 10
Troubleshooting
View all Zanussi ZRB35315WA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. Defrosting of the freezer The freezer compartment of this model, on the other hand, is a "no frost" type. This means that there is no buildup of frost when it is in operation, neither on the internal walls nor on the foods. The absence of frost is due to the continuous circulation of cold air inside the compartment, driven by an automatically controlled fan. Troubleshooting Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician or competent person must do the troubleshooting that is not in this manual. Important! There are some sounds during normal use (compressor, refrigerant circulation). Problem Possible cause Solution The appliance is noisy. The appliance is not installed prop- Check if the appliance stands stable erly. (all the feet should be on the floor). The appliance does not op- The plug is not connected to the erate. mains socket correctly. Connect the plug to the mains socket correctly. The appliance has no power. There is no voltage in the mains socket. Connect a different electrical appliance to the mains socket. Contact a qualified electrician. The light device does not work. The light device is in stand-by. Close and open the door. The unit is defective. Refer to "Replacing the control unit". The compressor operates The temperature is not set correctly. Set a higher temperature. continually. The door is not closed correctly. Refer to "Closing the door". The door has been opened too fre- Do not keep the door open longer quently. than necessary. The food temperature is too high. Let the food temperature decrease to room temperature before storage. The room temperature is too high. Decrease the room temperature. Water flows on the rear plate of the refrigerator. During the automatic defrosting process, frost defrosts on the rear plate. This is correct. Water flows into the refrig- The water outlet is clogged. erator. Clean the water outlet. Products prevent that water flows into the water collector. Make sure that products do not touch the rear plate. 10 www.zanussi.com