Zanussi ZRB35315WA Product Manaul - Page 11
Technical data, Installation
View all Zanussi ZRB35315WA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Problem The temperature in the appliance is too low/high. Possible cause The temperature regulator is not set correctly. Solution Set a higher/lower temperature. If your appliance is still not working properly after making the above checks, please contact the After Sales Centre. Replacing the control unit The appliance is equipped with a longlife LED interior light. Only service is allowed to replace the control unit. Contact your Service Center. Technical data Closing the door 1. Clean the door gaskets. 2. If necessary, replace the defective door gaskets. Contact the After Sales Service. Dimension Rising Time Voltage Frequency Height Width Depth 1845 mm 595 mm 642 mm 18 h 230-240 V 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Installation Caution! Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance. Positioning Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: Climate class SN N ST T Ambient temperature +10°C to + 32°C +16°C to + 32°C +16°C to + 38°C +16°C to + 43°C Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum www.zanussi.com 11