Zanussi ZUNN18ES1 User Manual - Page 16

Problem Possible cause Solution Temperature set in the appliance is too low and the ambient tempera‐ ture is too high. Set a higher temperature. Refer to "Control panel" chapter. Water flows on the floor. The melting water outlet is not con‐ Attach the melting water outlet to nected to the evaporative tray above the evaporative tray. the compressor. Temperature cannot be set. The FastFreeze function is switched on. Switch off FastFreeze function man‐ ually, or wait until the function deac‐ tivates automatically to set the tem‐ perature. Refer to "FastFreeze func‐ tion" section. The temperature in the appliance is The temperature is not set correctly. Set a higher/lower temperature. too low/too high. The door is not closed correctly. Refer to "Closing the door" section. The food products' temperature is too high. Let the food products temperature decrease to room temperature be‐ fore storage. Many food products are stored at the same time. Store less food products at the same time. The door has been opened often. Open the door only if necessary. The FastFreeze function is switched Refer to "FastFreeze function" sec‐ on. tion. There is no cold air circulation in the Make sure that there is cold air cir‐ appliance. culation in the appliance. Refer to "Hints and tips" chapter. DEMO appears on the display. The appliance is in the demonstra‐ tion mode. To exit the demonstration mode, press and hold the OK button for ap‐ proximately 10 seconds until you hear a long sound and the display turns off for a short time. A or or symbol is shown instead of numbers on the tempera‐ ture display. Temperature sensor problem. Contact the nearest Authorized Service Centre. The cooling system will continue to keep food products cold, but temperature adjustment will not be possible. If the advice does not lead to the desired result, call the nearest Authorized Service Centre. 8.2 Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to installation instructions. 3. If necessary, replace the defective door gaskets. Contact the Authorised Service Centre. 16 ENGLISH