Zanussi ZYNN8FW0 User Manual - Page 12

Problem Possible cause Solution The compressor does not start immediately after pressing the "FastFreeze", or after changing the temperature. Door is misaligned or interferes with ventilation grill. Door does not open easily. There is too much frost and ice. Water flows on the floor. Temperature cannot be set. The temperature in the appliance is too low/too high. The door is not closed correctly. The FastFreeze function is switched on. The compressor starts after a period of time. The appliance is not levelled. You attempted to re-open the door immediately after closing. The door is not closed correctly. The gasket is deformed or dirty. Food products are not wrapped properly. Temperature is set incorrectly. Appliance is fully loaded and is set to the lowest temperature. Temperature set in the appliance is too low and the ambient temperature is too high. The melting water outlet is not connected to the evaporative tray above the compressor. The "FastFreeze function" is switched on. The temperature is not set correctly. The door is not closed correctly. The food products' temperature is too high. Refer to "Closing the door" section. Refer to "FastFreeze function" section. This is normal, no error has occurred. Refer to installation instructions. Wait a few seconds between closing and re-opening of the door. Refer to "Closing the door" section. Refer to "Closing the door" section. Wrap the food products better. Refer to "Control Panel" chapter. Set a higher temperature. Refer to "Control Panel" chapter. Set a higher temperature. Refer to "Control Panel" chapter. Attach the melting water outlet to the evaporative tray. Switch off "FastFreeze function" manually, or wait until the function deactivates automatically to set the temperature. Refer to "FastFreeze function" section. Set a higher/lower temperature. Refer to "Closing the door" section. Let the food products temperature decrease to room temperature before storage. 12