Zenith DVB412 Operating Guide - Page 25
title, Reference - troubleshooting
UPC - 044642701277
View all Zenith DVB412 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
title Troubleshooting Symptom No power. Possible Cause • The power cord is disconnected. The power is on, but the DVD player does not work. No picture. No sound. • No disc is inserted. • The TV is not set to receive DVD signal output. • The video cable is not connected securely. • The equipment connected with the audio cable is not set to receive DVD signal output. • The power of the equipment connected with the audio cable is turned off. • The AUDIO options are set to the wrong position. The DVD player does not start playback. • An unplayable disc is inserted. • The rating level is set. The remote control does not work properly. • The remote control is not pointed at the remote sensor on the DVD player. • The remote control is too far from the DVD player. Correction • Plug the power cord into the wall outlet securely. • Insert a disc. (Check that the DVD or audio CD indicator in the display window is lit.) • Select the appropriate video input mode on the TV. • Connect the video cable securely. • Select the correct input mode of the audio receiver so you can listen to the sound from the DVD player. • Turn on the equipment connected with the audio cable. • Set the Digital Audio Output to the correct position, then turn on the DVD player again by pressing POWER. • Insert a playable disc. (Check the disc type, color system, and regional code.) • Cancel the rating function or change the rating level. • Point the remote control at the remote sensor of the DVD player. • Operate the remote control closer to the DVD player. Specifications General Power requirements: AC 120 V , 60 Hz Power consumption: 12W Dimensions (Approx.): 430 x 39 x 242 mm (W x H x D) without foot Weight (Approx.): 2.2 kg Operating temperature: 5 °C to 35 °C (41 °F to 95 °F) Operating humidity: 5 % to 90 % Outputs VIDEO OUT: 1 Vp-p 75 Ω, sync negative, RCA jack x 1 S-VIDEO OUT: (Y) 1.0 V (p-p), 75 Ω, negative sync, Mini DIN 4-pin x 1 (C) 0.3 V (p-p) 75 Ω COMPONENT VIDEO OUT: (Y) 1.0 V (p-p), 75 Ω,negative sync, RCA jack x 1 (Pb)/(Pr) 0.7 V (p-p), 75 Ω, RCA jack x 2 AUDIO OUT: 2.0 Vrms (1 KHz, 0 dB), 600 Ω, RCA jack (L, R) x 1 DIGITAL OUT (COAXIAL): 0.5 V (p-p), 75 Ω, RCA jack x 1 System Laser: Semiconductor laser, wavelength 650 nm Signal system: NTSC Frequency response: DVD (PCM 96 kHz): 8 Hz to 44 kHz DVD (PCM 48 kHz): 8 Hz to 22 kHz CD: 8 Hz to 20 kHz Signal-to-noise ratio: More than 100 dB (ANALOG OUT connectors only) Harmonic distortion: Less than 0.008% Dynamic range: More than 90 dB (DVD/CD) Accessories S-Video cable (1), Video cable (1), Audio cable (1), Remote control (1), Batteries (2) Reference Note: Design and specifications are subject to change prior notice. 25