Zenith Z52DC2D Operation Manual - Page 45

Programming the Remote The Remote Control for your HD receiver is a multi-brand or universal Remote Control that can be programmed to operate most remote-controllable devices of other manufacturers. Note: The Remote Control may not be able to control all models of other brands. 1. Test your Remote Control. To find out whether your remote control can operate the device with out programming, turn on the device such as a the VCR TV VCR CABLE DVD SAT and press the corresponding mode button (VCR) on the remote control while pointing at the device. Test the POWER and MODE LIGHT POWER CH +/- buttons to see if the device responds properly. If not, the 2 3 remote requires programming to operate the device. INPUT TV INPUT INFO 2. Turn on the device to be programmed. Then press the cor responding mode button on the Remote Control. RGB-PC TIMER HDMI/DVI 3. Press the POWER button and the MUTE button simulta neously. Now the Remote Control is ready to program the 4 code for the corresponding device. 123 456 4. There are two ways to find the right code for the device. 789 0 FLASHBK A. If you press the CH +/- buttons repeatedly, the codes will MUTE FAV change one at a time. Press the POWER button after each 3 + code change. If the right code is found, the device will turn off. SAP ADJUST VOL - CH 4 B. Enter a code number using the number buttons on the Remote Control. The right code numbers for the corresponding compo- EZ SOUND SRS APM EZ PIC nent can be found on the following pages. Again, if the code is correct, the device will turn off. 5. Press the EXIT button to store the program. RATIO CC FREEZE GUIDE 6. Test the Remote Control functions to see if the device responds properly. If not, repeat from step 2. ENTER MENU EXIT 5 Owner's Manual 45