ZyXEL EMG3425 User Guide - Page 95
DHCP Server Advanced Screen
View all ZyXEL EMG3425 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Chapter 11 DHCP Server Figure 52 Network > DHCP Server > General The following table describes the labels in this screen. Table 35 Network > DHCP Server > General LABEL DHCP Server DESCRIPTION Select Enable to activate DHCP for LAN. IP Pool Starting Address Pool Size Apply Cancel DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows individual clients (computers) to obtain TCP/IP configuration at startup from a server. Enable the DHCP server unless your ISP instructs you to do otherwise. Select Disable to stop the EMG3425-Q10A acting as a DHCP server. When configured as a server, the EMG3425-Q10A provides TCP/IP configuration for the clients. If not, DHCP service is disabled and you must have another DHCP server on your LAN, or else the computers must be manually configured. When set as a server, fill in the following four fields. This field specifies the first of the contiguous addresses in the IP address pool for LAN. This field specifies the size, or count of the IP address pool for LAN. Click Apply to save your changes back to the EMG3425-Q10A. Click Cancel to begin configuring this screen afresh. 11.3 DHCP Server Advanced Screen This screen allows you to assign IP addresses on the LAN to specific individual computers based on their MAC addresses. You can also use this screen to configure the DNS server information that the EMG3425-Q10A sends to the DHCP clients. To change your EMG3425-Q10A's static DHCP settings, click Network > DHCP Server > Advanced. The following screen displays. EMG3425-Q10A User's Guide 95