ZyXEL IES-5112 Series User Guide - Page 32
Removing a Splitter Chassis Card, Tightening Splitter Chassis Card Thumbscrews
View all ZyXEL IES-5112 Series manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Chapter 2 Hardware Installation and Connections Figure 25 Tightening Splitter Chassis Card Thumbscrews 2.3.4 Removing a Splitter Chassis Card Use the following procedure to remove a splitter or extension card from the splitter chassis. 1 Disconnect the cable from the card. 2 Loosen the two thumbscrews. 3 Grasp the handles on the front panel of the card and start to pull the card out. 4 After you have the card partially out of the splitter chassis, place one hand under the card to support it. 5 Slide the card out of the slot. 32 IES-5106M / IES-5112M / IES-6000M User's Guide
Chapter 2 Hardware Installation and Connections
IES-5106M / IES-5112M / IES-6000M User’s Guide
32
Figure 25
Tightening Splitter Chassis Card Thumbscrews
2.3.4
Removing a Splitter Chassis Card
Use the following procedure to remove a splitter or extension card from the
splitter chassis.
1
Disconnect the cable from the card.
2
Loosen the two thumbscrews.
3
Grasp the handles on the front panel of the card and start to pull the card out.
4
After you have the card partially out of the splitter chassis, place one hand under
the card to support it.
5
Slide the card out of the slot.