ZyXEL MGS-3712 User Guide - Page 328

Chapter 34 Access Control You can specify a group of one or more "trusted computers" from which an administrator may use a service to manage the Switch. Click Access Control to return to the Access Control screen. Figure 182 Management > Access Control > Remote Management The following table describes the labels in this screen. Table 112 Management > Access Control > Remote Management LABEL DESCRIPTION Entry This is the client set index number. A "client set" is a group of one or more "trusted computers" from which an administrator may use a service to manage the Switch. Active Select this check box to activate this secured client set. Clear the check box if you wish to temporarily disable the set without deleting it. Start Address Configure the IP address range of trusted computers from which you can manage this Switch. End Address Telnet/FTP/ HTTP/ICMP/ SNMP/SSH/ HTTPS Apply Cancel The Switch checks if the client IP address of a computer requesting a service or protocol matches the range set here. The Switch immediately disconnects the session if it does not match. Select services that may be used for managing the Switch from the specified trusted computers. Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the nonvolatile memory when you are done configuring. Click Cancel to begin configuring this screen afresh. 328 MGS-3712/MGS-3712F User's Guide