ZyXEL NWA1123-AC HD User Guide - Page 187
Telnet, Configuration > System >, TELNET, LABEL, DESCRIPTION
View all ZyXEL NWA1123-AC HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 187 highlights
Chapter 17 System Figure 115 SSH Example 2: Test $ telnet 192.168.1.2 22 Trying 192.168.1.2... Connected to 192.168.1.2. Escape character is '^]'. SSH-1.5-1.0.0 2 Enter "ssh -2 192.168.1.2". This command forces your computer to connect to the Zyxel Device using SSH version 1. If this is the first time you are connecting to the Zyxel Device using SSH, a message displays prompting you to save the host information of the Zyxel Device. Type "yes" and press [ENTER]. Then enter the password to log in to the Zyxel Device. Figure 116 SSH Example 2: Log in $ ssh -2 192.168.1.2 The authenticity of host '192.168.1.2 (192.168.1.2)' can't be established. RSA1 key fingerprint is 21:6c:07:25:7e:f4:75:80:ec:af:bd:d4:3d:80:53:d1. Are you sure you want to continue connecting (yes/no)? yes Warning: Permanently added '192.168.1.2' (RSA1) to the list of known hosts. [email protected]'s password: 3 The CLI screen displays next. 17.7 Telnet You can use Telnet to access the Zyxel Device's command line interface. Click Configuration > System > TELNET to configure your Zyxel Device for remote Telnet access. Use this screen to enable or disable Telnet and set the server port number. Figure 117 Configuration > System > TELNET The following table describes the labels in this screen. Table 81 Configuration > System > TELNET LABEL DESCRIPTION Enable Select the check box to allow or disallow the computer with the IP address that matches the IP address(es) in the Service Control table to access the Zyxel Device CLI using this service. Server Port You may change the server port number for a service if needed, however you must use the same port number in order to use that service for remote management. NWA/WAC/WAX Series User's Guide 187