ZyXEL P-2612HNU-F3F User Guide - Page 103
UBR Without PCR, Non Realtime VBR, Realtime VBR, EtherWAN, Routing, WAN Service Type
View all ZyXEL P-2612HNU-F3F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Chapter 5 Broadband Table 8 Broadband Add/Edit: Routing- IPoE (continued) Label DESCRIPTION Peak Cell Rate Divide the DSL line rate (bps) by 424 (the size of an ATM cell) to find the Peak Cell Rate (PCR). This is the maximum rate at which the sender can send cells. Type the PCR here. Sustainable Cell Rate This field is not available when you select UBR Without PCR. The Sustain Cell Rate (SCR) sets the average cell rate (long-term) that can be transmitted. Type the SCR, which must be less than the PCR. Note that system default is 0 cells/sec. Maximum Burst Size This field is available only when you select Non Realtime VBR or Realtime VBR. Maximum Burst Size (MBS) refers to the maximum number of cells that can be sent at the peak rate. Type the MBS, which is less than 65535. VLAN Enable VLAN Enter 802.1P Priority This field is available only when you select Non Realtime VBR or Realtime VBR. This section is available only when you select EtherWAN in the Type field. Select this to add the VLAN tag (specified below) to the outgoing traffic through this connection. IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that contains bits to define class of service. Enter 802.1Q VLAN ID IP Address Obtain an IP Address Automatically Enable DHCP Option 60 Vendor Class Identifier Static IP Address IP Address Subnet Mask Gateway IP Address Routing Feature NAT Enable Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection. The greater the number, the higher the priority level. Type the VLAN ID number (from 1 to 4094) for traffic through this connection. This section is available only when you select Routing in the Mode field and IPoE in the WAN Service Type field. A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is not fixed; the ISP assigns you a different one each time you connect to the Internet. Select this if you want to get a dynamic IP address from the ISP. Select this to identify the vendor and functionality of the ZyXEL Device in DHCP requests that the ZyXEL Device sends to a DHCP server when getting a WAN IP address. Enter the Vendor Class Identifier (Option 60), such as the type of the hardware or firmware. Select this option If the ISP assigned a fixed IP address. Enter the static IP address provided by your ISP. Enter the subnet mask provided by your ISP. Enter the gateway IP address provided by your ISP. Select this option to activate NAT on this connection. P-2612HNU(L)-FxF User's Guide 103