ZyXEL P-2812HNU-F1 User Guide - Page 185
Quality of Service QoS, P-2812HNUL-Fx Series User's Guide
View all ZyXEL P-2812HNU-F1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 185 highlights
Chapter 9 Quality of Service (QoS) Table 43 Class Setup: Add/Edit (continued) LABEL DESCRIPTION MAC Mask Type the mask for the specified MAC address to determine which bits a packet's MAC address should match. IP Address IP Subnet Mask Port Range Exclude Others 802.1p Enter "f" for each bit of the specified source MAC address that the traffic's MAC address should match. Enter "0" for the bit(s) of the matched traffic's MAC address, which can be of any hexadecimal character(s). For example, if you set the MAC address to 00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet with a MAC address of 00:13:49:12:34:56 matches this criteria. Select the check box and enter the destination IP address in dotted decimal notation. A blank source IP address means any source IP address. Enter the destination subnet mask. If you select TCP or UDP in the IP Protocol field, select the check box and enter the port number(s) of the source. Select this option to exclude the packets that match the specified criteria from this classifier. This field is available only when you select 802.1Q in the Ether Type field. IP Protocol Select this option and select a priority level (between 0 and 7) from the drop down list box."0" is the lowest priority level and "7" is the highest. This field is available only when you select IP in the Ether Type field. IP Packet Length DSCP Select this option and select the protocol (service type) from TCP or UDP. If you select User defined, enter the protocol (service type) number. This field is available only when you select IP in the Ether Type field. Select this option and enter the minimum and maximum packet length (from 46 to 1504) in the fields provided. This field is available only when you select IP in the Ether Type field. TCP ACK Select this option and specify a DSCP (DiffServ Code Point) number between 0 and 63 in the field provided. This field is available only when you select IP in the Ether Type field. DHCP If you select this option, the matched TCP packets must contain the ACK (Acknowledge) flag. This field is available only when you select IP in the Ether Type field, and UDP in the IP Protocol field. Select this option and select a DHCP option. If you select Vendor Class ID (DHCP Option 60), enter the Class ID of the matched traffic, such as the type of the hardware or firmware. If you select ClientID (DHCP Option 61), enter the Type of the matched traffic and Client ID of the DHCP client. If you select User Class ID (DHCP Option 77), enter the User Class Data, which is a string that identifies the user's category or application type in the matched DHCP packets. Service Exclude If you select VendorSpecificIntro (DHCP Option 125), enter the Enterprise Number of the software of the matched traffic and Vendor Class Data used by all the DHCP clients. Select the service classification of the traffic. Select this option to exclude the packets that match the specified criteria from this classifier. P-2812HNU(L)-Fx Series User's Guide 185