ZyXEL P-793H v2 User Guide - Page 345
Configuring a Server behind NAT
View all ZyXEL P-793H v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 345 highlights
Chapter 30 NAT Setup Table 126 Menu 15.1.1.1: Address Mapping Rule (continued) FIELD DESCRIPTION End Enter the ending local IP address (ILA). If the rule is for all local IPs, then put the Start IP as 0.0.0.0 and the End IP as 255.255.255.255. This field is N/A for One-to-One and Server types. Global IP These fields are enabled depending on the Type. Start Enter the starting global IP address (IGA). If you have a dynamic IP, enter 0.0.0.0 as the Global IP Start. Note that Global IP Start can be set to 0.0.0.0 only if the types are Many-to-One or Server. End Enter the ending global IP address (IGA). This field is N/A for One-to-One, Many-to-One and Server types. Server This field is available only when you select Server in the Type field. Select Mapping which server mapping set to use for this rule. Set Once you have finished configuring a rule in this menu, press [ENTER] at the message "Press ENTER to Confirm..." to save your configuration, or press [ESC] to cancel. 30.3 Configuring a Server behind NAT Note: If you do not assign a Default Server IP address, the P-793H v2 discards all packets received for ports that are not specified here or in the remote management setup. Follow these steps to configure a server behind NAT: 1 Enter 15 in the main menu to go to Menu 15 - NAT Setup. 2 Enter 2 to open menu 15.2 (and configure the address mapping rules for the WAN port on a P-793H v2 with a single WAN port). Figure 165 Menu 15.2: NAT Server Sets Menu 15.2 - NAT Server Sets 1. Server Set 1 (Used for SUA Only) 2. Server Set 2 3. Server Set 3 4. Server Set 4 5. Server Set 5 6. Server Set 6 7. Server Set 7 8. Server Set 8 9. Server Set 9 10. Server Set 10 P-793H v2 User's Guide 345