ZyXEL PLA5405 User Guide - Page 19
Installing the Utility, 3.1 Windows, 3.1.1 System Requirements, Windows - manual
View all ZyXEL PLA5405 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
CHAPTER 3 Installing the Utility This chapter guides you through the installation of the configuration utility for your PLA. 3.1 Windows This section uses the Windows XP screens as an example to show you how to install the Windows vesion of the ZyXEL PLA Series Configuration utility. 3.1.1 System Requirements At the time of writing, the ZyXEL PLA Series Configuration utility is compatible with: • Windows XP (32-bit version) • Windows XP (64-bit version) • Windows Vista (32-bit version) • Windows Vista (64-bit version) • Windows 7 (32-bit version) • Windows 7 (64-bit version) • Windows 8 (32-bit version) • Windows 8 (64-bit version) Note: To check for your Windows operating system version, right-click on My Computer > Properties. You should see this information in the General tab. Microsoft's .NET Framework version 4 and WinPcap 4.1.3 software are necessary for the installation of the ZyXEL PLA Series Configuration utility. The utility automatically installs WinPcap 4.1.3 and .NET Framework version 4 on all supported operating systems (if it's not already installed on your computer). 3.1.2 Installing the Utility Follow the steps below to install WinPcap 4.1.3, .NET Framework version 4 and the ZyXEL PLA Series Configuration utility on your computer. 1 Insert the included CD into your computer's CD-ROM drive. The setup utility runs automatically. Alternatively this can also be done manually by double clicking the setup.exe file on the CD. If WinPcap 4.1.3 is already installed on your computer, the following screen appears. Click Cancel and go to step 5. PLA Series User's Guide 19