ZyXEL PLA5405 User Guide - Page 25
Macintosh (Mac), 3.2.1 Supported OSs, 3.2.2 Installing the Utility, Supported OSs
View all ZyXEL PLA5405 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Chapter 3 Installing the Utility Figure 9 Installation Complete Note: You may be asked to restart your computer when the installation is complete. Click "Yes" to restart your computer. If you select "No, I will restart my computer later", you will not be able to launch the utility until after a restart of your computer. 3.2 Macintosh (Mac) This section uses the Mac OS X 10.8 screens as an example to show you how to install the Mac vesion of the ZyXEL PLA Series Configuration utility. 3.2.1 Supported OSs At the time of writing, the following Mac operating systems support the ZyXEL PLA Series Configuration utility: • Mac OS X 10.6 • Mac OS X 10.7 • Mac OS X 10.8 3.2.2 Installing the Utility Follow the steps below to install the ZyXEL PLA Series Configuration utility on your Mac computer. 1 Insert the included CD into your computer's CD-ROM drive. 2 Double-click the PLA Utility 1.0.0.mpkg file on the CD to run the installation program. When it opens, follow the on-screen instructions. PLA Series User's Guide 25