iRobot Scooba 350 Product Manual - Page 14

 Scooba's Cleaning System Scooba uses four cleaning methods in every pass. 1 3 4 2 1 P reps - Scooba picks up loose dirt and light debris from the floor. You do not need to sweep the floor before using Scooba unless you have large objects such as pebbles or large food particles on the floor. 2 W ashes - Scooba continuously lays down a small amount of fresh cleaning solution. 3 S crubs - Scooba gently scrubs to clean spills and grime. 4 D ries - Scooba's squeegee vacuum picks up dirty water and debris, leaving your floor clean and dry. Scooba will clean until it has used all of the solution in the Clean tank, approximately 45 minutes. At the end of a cleaning cycle, Scooba will enter a drying mode. Internal Drying Mode At the end of the cleaning cycle, Scooba will enter a brief internal drying mode to remove any liquid remaining on its brushes and inside its cleaning mechanisms. During this time Scooba's Clean light will blink. TIP: If you wish to end a cleaning cycle early, iRobot recommends activating the internal drying mode first: • To start drying mode while the robot is cleaning, just press Clean. • T o start drying mode when Scooba is off, press Power and then press Clean twice. 14 iRobot Scooba Owner's Manual